Knape&Vogt FXTM181 User manual

4.1 4.2
5.15.0
Slide the
monitor onto
the vesa plate
until the quick
connect snaps
into place
Ax the six (6)
velcro hook and
loops to the
keyboard tray
Position and
press the
keyboard onto
the tray
Monitor mount
allows for 90° vesa
rotation
Tighten or loosen
set screws on
both sides to
disable auto-
retract feature
Actuate lever
for height
adjustment
OOLS REQUIRED
Wall Mount Console Screw Pad Pan Head Screw Toggler
Mouse cable
manager
FXTM181 Rev. C FXTM181 Rev. C
INSTALLATION WARNINGS: Read the entire instruction sheet before you begin installation or
assembly. Installer must verify that the wall will safely support the combined weight of all the
attached equipment and hardware. Improper installation of this product can cause extensive
property damage or serious personal injury, either during or after the installation. It is the
responsibility of the installer to ensure that all applications including wood, concrete, block, brick,
steel, etc. are secured properly to code. California installations could require specific anchorage,
and additional mounting screws. Check with local authorities for codes in your area. Other
seismic states have similar regulations.
Warning: Max load 20 lbs of applied equipment including but not limited to: LCD, keyboard,
mouse, cabling and peripherals.
DISCLAIMER: The Manufacturer and/or Distributor will bear no responsibility for any damages of
any kind arising from any improper installation of this product. Because wall construction varies
widely and the ultimate method of mounting is out of the Manufacturers or Distributors control,
it is imperative that the installer consult with local engineering, architectural, or construction
personal to ensure the wall is constructed properly and to code to handle the applied load.
PARTS IN A BOXTOOLS REQUIRED
INSTALLATION INSTRUCTIONS
For Flush wall mount work center
STEP 4

1.0 3.0
1.1
Measure
44" from
the oor
to the
bottom of
the wall
plate
Level
wall
plate,
install
using
screws or
toggler
bolts
provided
Utilize the provided
cable management wrap
to bundle the wires
Cables can exit the top
or the bottom of the
Fusion mount
Holding the wires
behind the cable
management
cover, slide the
cables into the
slot leaving
approximately
13–15" of slack
(for optimal height
adjustment)
Attach the plastic
end caps to the
top and bottom of
the Fusion mount
with the screws
provided
Align the Fusion mount
over the track, then
slide it down the wall
plate until the Fusion
stops sliding
Secure the Fusion
mount to the wall
plate with the screw
provided
44"
Floor
3.1
4.03.2
2.0
1.2 Attach the quick connect bracket
to the back of the monitor with the
screws provided
Insert and
tighten screw
2 3
Installation Instructions: FXTM181 Installation Instructions: FXTM181
STEP 1 STEP 3
STEP 2