Koala Kare KB102 Series User manual

KB102 Child Protection Seat (CPS)
Silla de protectora para niños
Siège de sécurité pour enfant (SSE)
Kinder-Sicherheitssitz (KS)
®
You are responsible for the safe operation of this unit.
KOALA KARE PRODUCTS
Installation and Operation Instructions
Koala Kare Products 6982 S Quentin St. Centennial, CO 80112
IMPORTANT. RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.
IMPORTANTE. GUÁRDELO PARA FUTURAS CONSULTAS. LEER ATENTAMENTE.
IMPORTANT. À CONSERVER POUR INFORMATION. À LIRE ATTENTIVEMENT.
WICHTIG. ZUR SPÄTEREN BEZUGNAHME AUFBEWAHREN. BITTE SORGFÄLTIG
DURCHLESEN.

Please Note:
Child Protection Seat.
Koala Kare Products is not responsible if the seat is installed improperly.
You are responsible for the safe operation of this unit.
Not intended to hold more than 50 lbs.
Inspection Criteria:
A properly maintained unit:
– Opens and closes smoothly
–
Has two end caps located on lower sides of unit.
– Has fastening nut located at end of rod.
– Has both ends of a functioning, non-frayed strap, buckle clicks when closed and strap is
attached at both ends of the unit.
Measuring
Tape TOOLS NEEDED
3/8” Drill
Bit
Gloves Phillips Head
Screwdriver
Level Pencil
OPERATING INSTRUCTIONS
HARDWARE PROVIDED
Four ¼” Bolts and Washers Four Threaded Barrel Bolts
Using Restraint System
When a child is in the seat, the strap runs from the seat bottom, between child’s legs, up to the
waist where it fastens to the shoulder straps. Shoulder straps extend snugly over the shoulders
and between the legs fastening at the waist. When the seat is open and child is in place, straps
should hold child securely.
1

2
Step 1.
The Child Protection Seat (CPS) is
designed to be mounted on a bathroom
be mounted on a side wall (hardware
not included). Establish proper CPS
placement, taking door swing and
clearance into consideration.
Step 2.
Place the bottom of the unit 2” (51 mm)
above the bottom of the partition or 14”
higher. Use the CPS as a template for
locating and marking the mounting holes.
Step 3.
After establishing the proper placement of
the four mounting holes, drill through the
partition using a 3/8” (10 mm) drill bit.
Step 4.
Insert the four threaded barrel bolts
(supplied) from the outside of the partition.
Mount the unit using the four ¼” (6 mm)
bolts and washers.
Step 5.
Position Koala sign (supplied) on
the outside of the restroom door.
KB102 Child Protection Seat (CPS)
Model Number KB102
INSTALLATION INSTRUCTIONS