Koala Kare KB110-SSWM User manual

KB110-SSWM Baby Changing Station
Cambiador Plegable
Table à Langer
Babywickelstation
®
Your unit can be installed to meet ADA regulations when and where applicable. Refer to
Federal Register, Volume 56, No 144 28 CFR Part 36.
You are responsible for the safe operation of this unit.
KOALA KARE PRODUCTS
Installation and Operation Instructions
Koala Kare Products ǁ6982 S Quentin St. ǁCentennial, CO 80112 Toll Free: 888.733.3456 ǁ303.539.8300 ǁFax: 303.539.8399
www.koalabear.com
IMPORTANT. RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.
IMPORTANTE. GUÁRDELO PARA FUTURAS CONSULTAS. LEER ATENTAMENTE.
IMPORTANT. À CONSERVER POUR INFORMATION. À LIRE ATTENTIVEMENT.
WICHTIG. ZUR SPÄTEREN BEZUGNAHME AUFBEWAHREN. BITTE SORGFÄLTIG
DURCHLESEN.

Please Note:
To assure proper installation, it is suggested that a qualied person or carpenter install the
Koala Baby Changing Station. Koala Kare Products will not be responsible if the station is not installed
properly. Koala Baby Changing Stations have been tested to hold a substantial static load. The unit
must be attached to a permanent wall that is capable of holding a substantial load. The maximum
recommended total weight for this baby changing station (including baby and parcel bag) is 60 lbs.
Excessive weight may cause a hazardous or unstable condition to exist.
Using Restraint System
To fasten the waist restraint strap, place strap around child’s midsection, and push spring tabs into
buckle until both spring tabs lock in place with an audible “click”. Straps can be adjusted to make strap
tighter or looser as required.
Inspection Criteria:
A properly maintained baby changing station:
– Opens and closes smoothly.
– Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached at
both ends of the unit.
– Offers parents liners through a fully stocked liner dispenser. (Dispenser is built into unit.)
– Provides a clean, convenient place for customers to attend to their children.
Measuring
Tape TOOLS NEEDED
Stud
Finder
Gloves Phillips Head
Screwdriver
Level Pencil
Drill 1/8” Drill Bit
(regular)
7/32” Drill Bit
(masonry)
1/2” Drill Bit
(regular and
masonry)
OPERATING INSTRUCTIONS
HARDWARE PROVIDED
Four 1/4”x 3” Phillips Panhead Wood
Screws
Four ¾” x ¼” Flat Washers
1

Step 1.
Remove changing station from the shipping container
and check for any freight damage. Identify the best
location for installing the unit. Hold the unit in place
and open the bed. Make sure you have taken the
operating clearance into consideration.
Step 2.
Determine the best method for mounting based on the
type of wall. You may have left over hardware when
you have  nished installation.
Step 3.
The horizontal unit has four mounting holes provided
in the back wall, positioned on a 32” (812.8 mm) stud
center. If possible, locate the wood or metal wall studs
for fastening the unit in the desired location. If the walls
do not have studs on center as outlined, make sure at
least one side of the unit is installed onto the stud. Use
toggles (not supplied) for holes on the opposite side.
Step 4.
Find the stud where you will be attaching the left side
of the unit to the wall. Measure up from the  oor 44”
(1118 mm), at the center of the stud, and mark the
wall. Line up Hole A with the mark on the wall. Mark
remaining holes using a measuring tape to make sure the holes are precisely positioned. Hold unit in
place to verify. Use four ¼” x 3” (6.35 mm x 76.2 mm) panhead wood screws with washers (supplied)
when wall studs are available.
If the wall surface is masonry or tile over studs, use a 7/32” (5.56 mm) masonry drill bit for the pilot hole
until you hit the stud. Change bit to 1/8” (3.18 mm) regular drill bit. Use four ¼” x 3” (6.35 mm x 76.2 mm)
panhead wood screws with washers (supplied).
If the wall has metal studs or an underlying surface of concrete block, you will need to use toggles.
Additionally, if the wall has wooden studs that are not on 16” (406 mm) centers, you will need to use
toggles to secure one side of the unit. The other side should be secured to the stud using the screws
provided. You must allow for space inside the wall for the toggles to turn. This will vary depending on the
toggles used.
Step 5.
Position Koala sign (supplied) on the outside of the restroom door. Fill the built-in dispenser with
sanitary bed liners. Replacement parts can be purchased from your local distributor or by calling toll free
888.733.3456 or 303.539.8300 in the U.S.
Horizontal Baby Changing Station Surface Mounted
Model Numbers KB110-SSWM
INSTALLATION INSTRUCTIONS
2

ASTM F 2285-04
WARNING: Never leave child
unattended.
WARNING: Avoid serious injury from
falling or sliding out. Always use restraint system.
WARNING: Designed for Infants Only.
Age up to 3.5 years and weighing less than 50
lbs. Keep one hand on the child at all times.
Parcels or accessory items, or both, placed on
the unit may cause the unit to become unstable.
ADVERTENCIA: No deje nunca al
niño desatendido.
ADVERTENCIA: Evite que el niño se
lesione por caerse o resbalarse del cambiador
Use siempre el sistema de sujeción.
ADVERTENCIA: Diseñado
exclusivamente para bebés. Hasta 3 años y
medio de edad y con un peso inferior a 50
libras (22,5 kg aproximadamente). Mantenga
siempre al niño sujeto con una mano.
Colocar paquetes o accesorios, o ambas
cosas, encima del cambiador puede provocar
que se desestabilice.
3
ATTENTION : Ne laissez jamais un
enfant sans surveillance.
ATTENTION : Évitez les blessures
occasionnées par une chute ou une glissade.
Utilisez toujours le système de retenue.
ATTENTION : Conçue uniquement pour
les jeunes enfants. Jusqu’à 3 ans et demi et
moins de 50 lb (23 kg). Conservez une main sur
l’enfant à tout moment.
Tout paquet ou accessoire placé sur la table
peut créer un déséquilibre.
WARNUNG: Das Kind niemals
unbeaufsichtigt lassen.
WARNUNG: Ernsthafte Verletzungen
durch Herausfallen oder Herausrutschen
verhindern. Immer das Rückhaltesystem
verwenden.
WARNUNG: Dieses Produkt ist
nur für Kleinkinder bis zu 3 1/2 Jahren und
einem Gewicht von höchstens 50 lbs. (23 kg)
vorgesehen. Das Kind immer mit einer Hand
festhalten.
Durch Ablegen von Päckchen und Zubehör auf
der Wickelstation kann diese instabil werden.

ATTENTION : Ne laissez pas l’enfant sans
surveillance.
Tous les éléments d’assemblage doivent être
correctement  xés et véri és régulièrement.
Faites attention aux risques présentés par
un feu ouvert ou des sources de chaleur
telles que des radiateurs électriques ou des
cheminées à gaz à proximité de la table à
langer.
Nettoyez et désinfectez la table une fois
par jour ou plus en fonction de la fréquence
d’utilisation.
La table à langer est conçue pour supporter un
poids maximal de 15 kg.
Les pièces de rechange ou supplémentaires
doivent provenir du fabricant ou du distributeur
uniquement.
N’utilisez pas la table à langer si l’une des
pièces est endommagée ou manquante.
WARNUNG: Das Kind nie unbeaufsichtigt
lassen.
Alle Montageteile müssen stets richtig
angezogen und regelmäßig überprüft werden.
Achtung: Bei offenem Feuer und anderen
starken Hitzequellen, wie z. B. Heizsonnen,
Gasofen usw., in der Nähe der Wickelstation
besteht Brandgefahr.
Je nach Häu gkeit der Verwendung
mindestens einmal täglich reinigen und
desin zieren.
Die Wickelstation ist für ein Gewicht von
maximal 33 lbs. (15 kg) vorgesehen
Zusätzliche Teile oder Ersatzteile sollten
nur vom Hersteller oder einem Fachhändler
bezogen werden.
Die Wickelstation nicht verwenden, wenn Teile
beschädigt sind oder fehlen.
4
EN 12221:2008
WARNING: Do not leave the child unattended.
All assembly  ttings shall always be correctly
tightened and checked regularly.
Be aware of the risk of open  re and other
sources of strong heat, such as electric bar
 res, gas  res, etc. in the near vicinity of the
changing unit.
The changing unit is intended up to a
maximum weight of 15 kg.
Do not use changing unit if any parts are
broken or missing.
A changing pad is not required for this
product.
Additional or replacement parts shall only be
obtained from the manufacturer or distributor.
Unit should be cleaned once or more daily with
a clean nylon brush and spray disinfectant.
ADVERTENCIA: Nunca deje al niño solo en el
cambiador.
Todos los accesorios del montaje deben
ajustarse perfectamente y revisarse
periódicamente.
No olvide el riesgo de incendio que la
presencia de fuego u otras fuentes de calor,
como estufas eléctricas, de gas, etc. en las
proximidades del cambiador puede suponer.
Límpielo y desinféctelo una vez al día o más,
según la frecuencia de uso.
El cambiador ha sido diseñado para soportar
un peso máximo de 15 kg.
Las piezas de repuesto o adicionales
solamente deberán adquirirse al fabricante o
distribuidor.
No utilice el cambiador si faltan piezas o
alguna pieza está rota.

PN 433
April 2014