Kogan NBSEESW360A User manual

KIDS 360° SEESAW
NBSEESW360A

Ensure to read all warnings and instructions in this user guide prior to assembly and use.
Retain this user guide for future reference.
•This seesaw should be assembled by an adult.
•Adult supervision is required at all times when children are using the seesaw.
•Ensure the seesaw set is fully secure and placed on a level surface when in use.
•This seesaw should be installed on impact absorbing surfaces (for example, sand, wood
chips, rubber, foam).
•Do not use the seesaw on concrete, asphalt, or any other hard surfaces.
•Only use the seesaw in the areas that are at least 1.8m clear of structures, obstacles,
objects, electrical wires, and other people.
•This seesaw is intended for domestic indoor and outdoor use.
•Do not orientate the seesaw towards the sun if using outdoors.
•A maximum of 2 children can use the seesaw at any given time.
•This seesaw is suitable for children up to 25kg.
•This seesaw is suitable for children between 3–8 years old.
•The maximum fall height from this seesaw is 60cm. Ensure all screws and nuts are
checked for tightness regularly. Tighten if necessary.
•Over extended use, this seesaw may develop rust. Sand off the rusted areas and
repaint with non-lead based paint when required.
•Do not make modifications to the seesaw.
•Be aware that any exercises involving physical contact may result in potential injuries.
•If any component is damaged, stop use and contact help.Kogan.com for assistance.
•Inspect the seesaw periodically for any signs of regular wear and tear. A lack of
inspecting may lead the seesaw to become a potential safety hazard.
SAFETY & WARNINGS

OVERVIEW
AWasher
BScrew
CSeat
DNut
ECentral assembly
G Cap
H Base components
FBall cushion
I Needle
J Allen key

Step 1: Align the holes on the seats (C) and central assembly (E). Place a washer on top of
one of the aligned holes and using the Allen key (J), secure the screws through the washer
(A). Insert and tighten a nut (D) on the underside of the aligned hole.
Repeat this process for the remaining three aligned holes.
This completes the seat assembly.
ASSEMBLY

Step 2: Secure the base components (H) and cap (G) on top of each other.
This completes the base assembly.

Step 3: Place the seat assembly onto the base assembly.
Step 4: Secure the ball cushions (F) onto the seats (C).

Step 5: Inflate the ball cushions (F) using the needle (I) and an air pump (not supplied).

Assembly complete.

NOTES

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com