Kohler ALEO 99175T-4 User manual

1217947-2A-E 1
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTE:
1. Flush the water supply pipes thoroughly to remove debris.
2. For new installations, assemble the faucet to sink before installing.
3. The highest working pressure for handspray & shower head is 0.5MPa(5 bar). If it exceeds 0.5MPa(5 bar), a
pressure reducer is needed. The highest water and environment temperature is 60 ºC. Please keep handspray,
shower head and the shower arm away from heater, or it may become damaged and cause injury to the user.
HANDLE OPERATION
Open the handle gently. Turn clockwise for cold water, turn counter clockwise for hot water.
INSTALLATION INSTRUCTIONS
99175T-4 Pull-out Kitchen Faucet
ALEO
ROUGH-IN DIMENSIONS
235
123
221
257
156
64
114
63 Max.
271743
Ø25
Ø46
Ø25
88
Ø35~Ø40
5º
G1/2˝

1217947-2A-E 2 1217947-2A-E 3
INSTALLATION
Slide the washer(1) into the groove of the body(2) through the shank(3). Put the
faucet body kit into the mounting hole of the sink. Let the bottom of the body
against the deck.
Screw two screws(4) into the threaded ring(5). From underside of the sink,
place and tighten the washer(6), the metal washer(7) and threaded ring with two
screws onto the shank. Position the faucet so that the handle is on the right
side. Tighten two screws to secure faucet to sink.
Connect the hoses(9) with the two shorter copper pipes(8). The hose which
connects copper pipe with “COLD” label is for cold water. Attach the hoses(9) to
water supplies.
Put the brass weight(10) and clip(12) onto the hose assembly(11). Connect the
hose assembly(11) and copper pipe(14) with connector(13). Adjust and position
the brass weight and clip. Note: Don’t over distort the hoses. Please avoid the
wrong installation for the brass weight and clip as below.
Try to pull out the spray, check whether it can go back to its original position
smoothly or not. If not, position the brass weight again.
99175T-4 Pull-out Kitchen Faucet
ALEO
SERVICE PARTS
**Color code must be specified when ordering
INSTALLATION CHECKOUT
Ensure that all coupling nuts are tight. Ensure that the lever handle is in the off
position. Turn on the main water supply and drain, and check for leaks. Repair
as needed.
Remove the aerator(15). Turn on the faucet, run hot and cold water for about
one minute to remove any debris. Remove any debris from the aerator. Shut off
the faucet. Reinstall the aerator.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire
surface completely dry with clean soft cloth. Many cleaners may contain
chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
Errors
1
3
7
2
6
5
4
14
8
9
10
12
11
13
871578
1066106
1223415
1229693
1217924
58946
1217945**
833438
1068078
1213242**
1217944
1217934
1217928
1217925**
880096
1217935**
832751
834683
1217942
3008523
1213241
833730
870992
1004899
101131
1217930
1104495
22352
1267359
1073951
1217943
15
"LEAD FREE" is marked on the back of the faucet signifying its compliance with the United States AB1953
1242369**