Kohler Mazz R72511-SD-VS User manual

Installation Guide
3/8"
Bucket
1For Three-Hole Sinks:
Assemble as shown.
Important Information
For new installations, assemble the
faucet to the sink before installing the
sink.
Observe all local codes.
Shut off the water supply.
CAUTION: Risk of fresh water
contamination.
This faucet contains back-siphonage
protection. To prevent water
contamination, do not remove any
internal components from this faucet.
Record your model number below
for future reference:
3-Hole Only
3 orifices seulement
3 orificios solamente
Plastic
Plastique
Plástico
Metal
Métal
Metal
4Slide the washers onto the shank
and thread the ring onto the
shank.
1/4" (6 mm)
3Partially thread the screws into the
ring until they extend 1/4” (6 mm)
out the opposite side.
2For Single-Hole Sinks:
Install the faucet.
For Three-Hole Sinks: Install the
nuts on the studs and handtighten
securely.
For Three-Hole Sinks: Install the
faucet.
9Align the spray hose with the
outlet tube and click together.
8Attach the weight to the spray
hose.
7Turn on the water supplies.Flush
the hot and cold water for 1
minute.
6Connect and tighten the supply
hoses.
1/4"
(6 mm)
5Position the screws on the ring
to the front and back.Tighten the
screws.
14Install then fill the soap bottle. 13 Install the soap dispenser
escutcheon.
12Adjust the weight as needed for
proper positioning and operation.
11Check for smooth operation.
2" (51 mm) –
3" (76 mm)
10Position the weight on the spray
hose as shown.
1241700-2-B

To improve the flow, disconnect the
sprayhead and clean the screen
washer. Reassemble.
Faucet Maintenance:
With the water running, rub the
nozzles to dislodge debris.
15Install the flat end of the tube to
the pump. Install the pump.
Learn more about RV faucets and shower fixtures we have.