Konan labs Klp-120rgy-5k User manual

RGY LASER SHOW SYSTEM

Unpacking:

Thank you for purchasing this product. Please read user guide for safety and operations

information before using the product. Keep this manual for future reference. This product

can create perfect laser programs and effects since it has passed a series of strictly tests

before delivery. Please check the attachments listed on the page after opening the carton. In

the event of carton damage or attachment missing in transit, please contact your dealer or

our after sales service department.

Attachments:

1. Laser Light: 1PCS

2. Power Cable: 1PCS

3. User Guide: 1PCS

Notice:

1. Do not exposure the human eye direct to laser beam.

2. Do not turn on and off the unit frequently.

3. Before using this unit make sure the power supply is ground.

4. This unit is intended for indoor use only and should be prevented form water, moisture

and shake. The working temperature of this unit is 18～30℃, do not use this continuously

over 4 hours, otherwise it shortens the lifetime of the unit.

5. Use cleaning tissue to remove the dust absorbed on the external lenses periodically to

optimize light output.

6. Do not remove or break the warranty label, otherwise it void the warranty.

7. Always replace with the exact same type fuse, replacement with anything other than the

specified fuse can cause fire or electric shock and damage your unit, and will void your

manufactures warranty.

DANGER

LASER RADIATION AVOID EXPOSURE

TO BEAM CLASS 3B LASER PRODUCT

Page 1

General instructions

1. Voltage: 5V DC or AC110V to AC220V-240V, 50HZ-60HZ, Fuse: 2A/250V

2. Rated Power: 20W

3. Laser: 40mW green DPSS laser, red 80mW 650nm DPSS laser

Mix Yellow 120mW

4. Working Modes: Sound Active, AUTO

5. more than 100 patterns

6. Size: L*W*H=100*190*50mm Rear Panel Figure

7. Weight: 3.0Kg

1. AUTO and Sound Active Switch 2. Audio Sensitivity Knob

Features 3. Cooling Fan 4. Power Jack

1. Use Diode-Pumped Solid State laser, stable output and long working life.

Operation

2. Various programs

The laser beams are controlled by sound active, more than 50 laser patterns, over 200 1. Install the system in a suitable position (laying or appending).

laser effects. 2. Turn on the unit power, the unit begins reset, then the unit begins working.

3. LED Indicating and shut-off in sound active 3. The unit will react to the low frequencies of music via the internal microphone. Adjust

The panel has LED indicating for sound active. The unit will shut off after 8 seconds the audio sensitivity knob on the back of the unit to make the unit more or less sensitive

when the music stops. in sound active.The panel has LED indicating for sound active.

Front Panel

Troubleshooting