KONDATOR OSLO 438-LC15 User manual

User manual
Monitor Arm OSLO 438-LC15
438-LC15B
438-LC15W
Assembly Guide
Use the included
cable cover to finish
cable management.
Insert thicker cables into the groove
first. Keep the front end stable while
routing the cables from the arm
to the pole.
Inserting cables
into cable clips.
When the joint is loose, please use
the Allen Key (5mm) to tighten the arm.
Adjustment:
Use the Allen key provided to adjust
the tension to correspond to the
weight of the monitor. Twist the Allen
key in a clockwise
direction for heavier
monitors,and
counterclockwise
for lighter
monitors
Weight capacity for ~14kg monitors.
There are many components used in the construction of this unit.
Please consult authorized service personnel for the installation of this unit.
These loose items should be kept away from young children
while assembling your unit.

Assembly Guide Assembly Guide
Check-List
Desk thickness from 15mm~30mm.(max 30
with pad removed).Adjust and fix the clamp on
the desk.
Then put the plastic cover
through the pole and check
the pin position with the
hole together.
Place monitor facing downward on flat surface. Place arm and VESA mount on the
monitor back as figure and align to the screw holes. Secure them together with four
screws. Then tighten them up with screwdriver (not provided).
75mm × 75mm
100mm × 100mm
VESA interface
lnsert the arm with the fixed monitor onto the pole. Adjust to desired height
using the black plastic lever. To make the first arm completely rigid, use
Allen key 08 until the screw grips the pole 02 .Using Allen key 05 ,tighten
the remaining joints to achieve the same result.
Before assembly, please spend some time reading this manual and follow the
procedures step by step. Do not discard any of the packaging until you have
checked all the parts and the package of fittings.
lf you are missing any of the parts, please contact the seller from which you
purchased your products. The staff will do their best to help you.