Kontron 3.5"-eIO-GPA User manual

Kontron 3.5"-eIO-GPA - Quick Installation Guide - Version 1 - P/N: 0D2035EGPA010000 // 1

3.5"
-eIO-GPA - QUICK INSTALLATION GUIDE
Thank you for purchasing the Kontron 3.5"-eIO-GPA embedded board. This document provides information to allow you
to quickly install this product.
Packing Checklist
1. Take the 3.5"-eIO-GPA out of the packing box and check if the unit is properly secure in the plastic bag.
2. Check the contents of the carton box: (*: optional)
3.5"-eIO-GPA daughter board
3x fixing bolt
3x screw
Top Side Jumper and Internal Connector Locations
Jumper List
Item Designation Description
1 JP1 eDP Backlight & Panel Power Selection (optional)
2 JP3 Power Mode Selection
1
9
3 456 7 8
2
10

Kontron 3.5"-eIO-GPA - Quick Installation Guide - Version 1 - P/N: 0D2035EGPA010000 // 2
Internal Connector List
Item Designation Description
3 CN1 eDP Panel Connector (optional)
4 CN2 SMBus Wafer
5 CN3 I2C Wafer
6 CN4 GSPI Wafer
7 CN5 UART Wafer
8 CN6 Nano SIM Card Holder for MPCIE1 (optional)
9 CN7 Power Output Wafer
10 CN8 Activity Indicator Header for MPCIE1 (optional)
Jumper Setting
Power Mode Selection (JP3)
Jumper 1 Position Description
Pin 1-2 Pin 2-3
X - +12V Controller ENABLE (the system is powered by the power supply from CN14)
- X +12V Controller DISABLE (the system is powered by the power supply from SBC)
“X’’ = Jumper set (short) and ‘‘-’’ = jumper not set (open)
2
3
1

Kontron 3.5"-eIO-GPA - Quick Installation Guide - Version 1 - P/N: 0D2035EGPA010000 // 3
Bottom Side Internal Connector Locations
Item Designation Description
1 CN15 B2B Connector
2 MPCIE1 Mini-PCI Express Socket (optional)
Rear I/O Panel Connector Locations
Item Designation Description
1 CN9 2.5 GbE LAN1 RJ45 Connector
2 CN10 2.5 GbE LAN2 RJ45 Connector
3 CN11 DP Port 1 Connector
4 CN12 DP Port 2 Connector
5 CN14 11 V ~ 32 V Power Input Connector (availability depending on variants)
1
2
3
4
1
2
5