Kreg KCS-100 User manual

English 2
French 9
Spanish 17
OWNER’S MANUAL
We’re here to help.
We want you to have an exceptional project building experience.
If you have questions or need support, please get in touch.
1-800-447-8638 | [email protected]
Tell us about your experience.
Your opinion counts. And we’re always looking for ways to improve.
Share your feedback so we can keep growing and innovating for you.
www.kregtool.com/feedback
WARNING Every user must read and follow instructions and safety precautions in this manual.
Failure to do so could result in serious injury. Save manual for future reference.
Cabinet Installation System
Manual applies to Item # KCS-100 and KCS-400

2
Safety Precautions
WARNING The maximum cabinet weight for this product is 60 lbs (27.2 Kg). Loads
exceeding the maximum can result in serious injury.
WARNING Always ensure the wall brackets are mounted to either 2 studs, or 1 stud
and 2 drywall anchors located at either end of the bracket.
WARNING This product is intended to be used as temporary placement of the
cabinets. Always secure each cabinet to wall studs after initial placement.
WARNING Every user must read and follow instructions and safety precautions in
this manual. Failure to do so could result in serious injury. Save manual for future
reference.
WARNING Always wear personal protective equipment certied as such, including
safety glasses, hearing protection, and respiratory protection.
WARNING When using a power tool, always follow the manufacturer’s personal
protection equipment requirements.
WARNING Always ensure the cabinet bracket hardware engages at least 5/8 in.
material thickness.
WARNING Never attach the cabinet bracket hardware to the end grain of the
cabinet material.
WARNING Do not operate this tool or any machinery while under the inuence of
drugs, alcohol, or medications.
Table of Contents
Safety Precautions . . . . . . . . . .2
Pre-Installation . . . . . . . . . . . . 3
Recommended Tools (NotIncluded) 3
Hardware Included . . . . . . . . . 3
Product Description . . . . . . . . . 3
Installation. . . . . . . . . . . . . . . 4
Troubleshooting . . . . . . . . . . . . 7

3
Pre-Installation
Review this section before you begin. Ensure you have all tools/materials on hand
and compare the package with the items listed in the Hardware Included and Product
Description sections. If any item appears missing or lost, do not use this product.
Contact technical support or return product to place of purchase.
Recommended Tools (NotIncluded)
Pencil
Level (or Laser level) #2 Phillips drive bit Drill Stud nder
Hardware Included
AA BB CC
KCS-100
Part Description Qty.
AA #8 3/4" screws 26
BB #8 1-1/2" screws 13
CC Drywall anchor 9
KCS-400
Part Description Qty.
AA #8 3/4" screws 78
BB #8 1-1/2" screws 39
CC Drywall anchor 27
Product Description
A B
KCS-100
Part Description Qty.
A Cabinet brackets 13
B Wall bracket 4
KCS-400
Part Description Qty.
A Cabinet brackets 39
B Wall bracket 13

4
Installation
IMPORTANT This system is designed for cabinets up to 60 lbs.
1 Attach Wall Bracket
a. Locate all studs in wall for cabinet installation.
b. Mark wall bracket sections at a height of 1 in. (2.54 cm) above the desired height
for the top of the wall cabinet.
c. Be sure to inset from the edge of the cabinet enough that it can be hidden with
top trim, if desired.
d. Attach each wall bracket section (B) to studs in wall using the supplied 1-1/2
in. (3.81cm) screws (BB), leveling as you go. Cut to length with a hack saw if
needed.
Note If there are very clear gaps behind the rail due to uneven walls, shim as
needed for proper support (shims not included).
e. With each 2 ft. section, attach at least 2 wall studs. If this isn’t possible, use the
supplied drywall anchors (CC) for added support. For best results, there should
be either a stud or anchor support within 3 predrilled holes from each end of the
wall bracket for proper support and leveling.
BB
BB
BB
CC
B

5
2 Install Cabinet Brackets
a. Install the cabinet brackets (A) on the top of the wall cabinet (1) with the back of
the bracket 1-1/2 in. (3.81 cm.) from the back of the cabinet using the supplied
3/4in. screws (AA). Do not to attach to end grain of cabinet sides.
A
1
AA
1-1/2 in.
(3.81 cm)
A
1
AA
1-1/2 in.
(3.81 cm)
1
Note The top of the cabinet must be ush with the sides. If it isn’t, cut a scrap piece
of plywood or lumber (1) the correct thickness to make it ush and attach securely to
the top. The cabinet top must also be 1/2 in. (1.27cm) thick or thicker. If the cabinet
is 24in. (60.96 cm) wide or smaller, two brackets should be sufcient. More brackets
may be needed if the cabinet is wider, taller, or deeper than a typical wall cabinet.
1
1/2 in.
(1.27 cm)

6
3 Hang Wall Cabinet
a. Lift the wall cabinet up and gently hang it in place on the wall brackets. This
temporarily supports the cabinet while you position, level, and permanently
attach it in place to the studs in the wall.
Tip If space above the cabinet allows, you can remove the wall and cabinet
brackets after the cabinet has been permanently installed.
A
B
B
A

7
Troubleshooting
Problem Possible Cause Solution
Wall brackets not level Missed a stud with a
screw Find a stud or use a drywall anchor.
Cabinet brackets don’t
reach wall bracket
Cabinet bracket out of
position
Loosen screws on cabinet brackets and
reposition so that the cabinet bracket can
reach the wall bracket.
Cabinet not level Wall bracket moved Reattach wall bracket with more stud and
anchor support.

EXPLORE. BUILD. SHARE.
We’re makers just like you.
That’s why we love to see what you’re working on.
Share with the community and get inspired!
#madewithKreg
Get free plans, project resources, and more.
kregtool.com and buildsomething.com
12/2021 108093 V1

GUIDE D’UTILISATEUR
Nous sommes là pour vous aider.
Nous voulons que votre projet de construction se déroule de manière optimale.
Si vous avez des questions ou si vous avez besoin d’aide, n’hésitez pas à nous contacter.
1800447-8638 | [email protected]
Parlez-nous de votre expérience.
Votre opinion compte. Et nous sommes toujours à la recherche de moyens de nous améliorer.
Partagez vos commentaires an que nous puissions continuer à croître et à innover, pour vous.
www.kregtool.com/feedback
AVERTISSEMENT Chaque utilisateur doit lire et suivre les consignes et les précautions de sécurité de ce
manuel. Respectez ces consignes an d’éviter tout risque de blessures graves. Conservez le manuel pour
une utilisation ultérieure.
Système d’installation d’armoire
Le guide s’applique aux articles n° KCS-100 et KCS-400

10
Précautions de sécurité
AVERTISSEMENT Le poids maximum de l’armoire pour ce produit est 60lb
(27,2kg). Des charges dépassant le poids maximum peuvent entraîner des blessures
graves.
AVERTISSEMENT Assurez-vous toujours que les supports de xation murale soient
xés sur 1 ou 2montants et 2chevilles pour cloison sèche qui se trouvent à chaque
extrémité du support.
AVERTISSEMENT Ce produit est prévu pour le placement temporaire d’armoires.
Fixez toujours chaque armoire aux montants muraux après le placement initial.
AVERTISSEMENT Chaque utilisateur doit lire et suivre les instructions ainsi que les
précautions liées à la sécurité dans ce manuel. Respectez cette consigne an d’éviter
tout risque de blessures graves. Conservez le manuel pour une utilisation ultérieure.
AVERTISSEMENT Portez toujours un équipement de protection individuelle certié,
notamment des lunettes de sécurité ainsi qu’une protection auditive et respiratoire.
AVERTISSEMENT Lorsque vous utilisez un outil électrique, respectez toujours les
exigences du fabricant en matière d’équipement de protection individuelle.
AVERTISSEMENT Assurez-vous toujours que la quincaillerie de support pour
l’armoire s’engage au moins à 5/8po dans l’épaisseur du matériau.
AVERTISSEMENT Ne xez jamais la quincaillerie de support pour l’armoire à
l’extrémité du matériau de l’armoire.
AVERTISSEMENT N’utilisez pas cet outil ou toute autre machinerie lorsque vous
êtes sous l’inuence de drogues, d’alcool ou de médicaments.
Table des matières
Précautions de sécurité . . . . . . 10
Avant l’installation . . . . . . . . . 11
Outils recommandés (non inclus) . 11
Quincaillerie fournie . . . . . . . . 11
Description du produit . . . . . . 11
Installation. . . . . . . . . . . . . . 12
Dépannage . . . . . . . . . . . . . 15