
TAKING OUT THE TREE
PUTTING UP THE TREE
To release the foot pedal, first
raise the red lock into the unlock
position (green).
Gently lift the foot pedal upwards
to open the clamping mechanism.
The clamps will spring (!) into a
vertical position step by step.
Give the trunk a straight and even
cut. Set the trunk in the center of the
stand over the spike. Make sure the
trunk and spike have contact but do
not use force. Do not drill a hole into
the trunk.
The foot pedal must be lifted
with suitable foot wear. To
avoid injury do not place any
body parts (fingers) in area of
the clamps.
The trunk may not be drilled in the
middle. If the cut is inclined or the
trunk is drilled, re-cutting the trunk
is necessary. An uneven or in-
clined cut causes reduced stability
and enhances the risk of the tree
to fall.
To take out the Christ-
mas tree raise the lock
into the unlock position
(green).
Hold the tree in an upright
position. Lift the foot ped-
al. The clamps will spring
(!) into a vertical position.
Now you can take out the
Christmas tree.
To drain the water, tip the
stand towards the level in-
dicator opening into a sink.
Wash the stand with a soft
sponge and a mild deter-
gent. Rinse thoroughly.
The foot pedal must be
lifted with suitable foot
wear.
Do not use any chemi-
cals or abrasive clean-
ers. Dry completely prior
to storage.
• Do not use the tree stand for any other purpose like
sign plates, clothes dryers, flag poles or sunshades etc.
KRINNER will not cover any damage done by misuse
of this Christmas tree stand. This Christmas tree stand is
for indoor use only.
• Before putting up your Christmas tree, ensure that your
tree stand has a secure base. A thick carpet is not a
secure base! Only use the tree stand on a solid, level
and even surface. Uneven or inclined surfaces cause
reduced stability and enhance the risk of the tree to fall.
• To prevent possible damage to your carpet or floor, the
use of a heavy plastic sheet underneath the Christmas
tree stand is recommended.
• To prevent floor damage due to possible leakage,
please check water tank for cracks and holes yearly
before tree setup. Check the water level indicator for
free movement. Use a pointed tool to pull the indicator
up and out. Wash with soap if there are sap residues.
• While pushing down the foot pedal with your feet, en-
sure that there are no hands or other body parts in be-
tween the clamps and the trunk as it can cause serious
injuries. The Christmas tree stand is not a toy! Do not
allow children to operate the tree stand. Make sure they
are not near the stand while setting up your tree.
• This Krinner Christmas tree stand is a safety product. Do
not alter the construction of the Krinner Christmas tree
stand. This will void the warranty. Do not use the stand if
it shows any structural damage.
• If electric lighting is used, do not allow this electric light-
ing to burn unattended. (!) Water is a conductor. Ensure
that electric wires are in a safe distance to the water tank
of the Christmas tree stand.
• Adding too much water will lead to overflowing and
may cause damage to the surface underneath. Strictly
follow the instructions under the chapter ‘Putting up the
tree (6.)’
• A fresh and green Christmas tree reduces the fire haz-
ard. The trunk must have a fresh, clean and even cut to
absorb water. Therefore always keep sufficient water in
the tree stand.
• Ensure that the tree is securely fastened, well balanced
and positioned in the middle of the tree stand before
applying decorations and lighting.
• Keep your tree away from fireplaces and open flames.
• For helpful tips and contact go to www.krinnerusa.com
SAFETY
When tree and trunk
are well positioned
and securely fastened,
slide the lock into the
red position (locked) to
secure the foot pedal.
Add tap water to keep your tree fresh. Slowly fill
the tank with tap water until the level indicator is
clearly visible. Stop adding water. Always keep
the inner container filled with tap water.
Overfilling can damage the seal and create
recurrent leaking, and may cause damage to
your floor covering. Please check the water
tank for cracks and holes yearly before tree
setup.
The foot pedal must be lifted
with suitable foot wear. To
avoid injury do not place any
body parts (fingers) in area of
the clamps.
Repeatedly push down the foot pedal to close the claws.
Push 2 claws opposite of each other(5.) lower than the
others to fully close the tree stand for storage. Stop push-
ing when claws are down and pedal is in horizontal
position. Hold pedal and bring lock back into secured
position (red).
To clean the tree stand
use a damp cloth and
water.
Once locked, you can let
go off the pedal. Now it
should be in a horizontal
position for storage.
Put the stand back in
the box provided for
this purpose.
1. 2.
~2cm
3.
4. 5. 6.
1. 2. 3. 4.
5. 6. 7.
Original vom Erfin
der
Push down the foot pedal. Repeat
pushing until the clamping me-
chanism securely fastens the
trunk.