4Krowne Metal Corporation |100 Haul Road |Wayne, NJ 07470
Phone: (800) 631-0442 |Fax: (973) 872-1129 |www.krowne.com
Limited Warranty
LIMITED WARRANTY
Krowne Metal Corporation, (herein referred to as "The Company"), 100 Haul Road, Wayne, New Jersey 07470 warrants machines, and parts, as set
out below.
Warranty of Machines: The Company warrants all new machines of its manufacture bearing the name "Krowne Metal Corporation" to be free
from defects in material and workmanship for a period of one (1) year after the date of installation or fteen (15) months after the date of shipment
by The Company, whichever occurs rst. [See below for special provisions relating to glasswashers.] The registration card must be submitted by fax
or online with The Company within ten (10) days after installation. If the registration is not submitted to The Company within such period, the war-
ranty will expire after one year from the date of shipment.
The Company will not assume any responsibility for extra costs for installation in any area where there are jurisdictional problems with local trades
or unions.
If a defect in workmanship or material is found to exist within the warranty period, The Company, at its election, will either repair or replace the
defective machine or accept return of the machine for full credit; provided; however, as to glasswashers, The Company's obligation with respect to
labor associated with any repairs shall end (a) 120 days after shipment, or (b) 90 days after installation, whichever occurs rst. In the event that The
Company elects to repair, the labor and work to be performed in connection with the warranty shall be done during regular working hours by The
Company's authorized service technician. Defective parts become the property of The Company. Use of replacement parts not authorized by The
Company will relieve The Company of all further liability in connection with its warranty. In no event will The Company's warranty obligation exceed
The Company's charge for the machine. The following are not covered by The Company's warranty:
a. Lighting of gas pilots or burners.
b. Cleaning of gas lines.
c. Replacement of fuses or resetting of overload breakers.
d. Adjustment of thermostats.
e. Adjustment of clutches.
f. Opening or closing of utility supply valves or switching of electrical supply current.
g. Cleaning of valves, strainers, screens, nozzles, or spray pipes.
h. Performance of regular maintenance and cleaning as outlined in operator’s guide.
i. Damages resulting from water conditions, accidents, alterations, improper use, abuse, tampering,
improper installation, or failure to follow maintenance and operation procedures.
j. Wear on Pulper cutter blocks, pulse vanes, and auger brush.
Examples of the defects not covered by warranty include, but are not limited to: (1) Damage to the exterior or interior nish as a result of the
above, (2) Use with utility service other than that designated on the rating plate, (3) Improper connection to utility service, (4) Inadequate or
excessive water pressure, (5) Corrosion from chemicals dispensed in excess of recommended concentrations, (6) Failure of electrical
components due to connection of chemical dispensing equipment installed by others, (7) Leaks or damage resulting from such leaks caused
by the installer, including those at machine table connections or by connection of chemical dispensing equipment installed by others,
(8) Failure to comply with local building codes, (9) Damage caused by labor dispute.
Warranty of Parts: The Company warrants all new machine parts produced or authorized by The Company to be free from defects in material and
workmanship for a period of 90 days from date of invoice. If any defect in material and workmanship is found to exist within the warranty period. The
Company will replace the defective part without charge.
DISCLAIMER OF WARRANTIES AND LIMITATIONS OF LIABILITY. THE COMPANY'S WARRANTY IS ONLY TO THE EXTENT REFLECTED ABOVE.
THE COMPANY MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED, TO ANY WARRANTY OF
MERCHANTABILITY, OR FITNESS OF PURPOSE. THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
THE REMEDIES SET OUT ABOVE ARE THE EXCLUSIVE REMEDIES FOR ANY DEFECTS FOUND TO EXIST IN THE COMPANY'S DISHWASHING
MACHINES AND THE COMPANY'S PARTS, AND ALL OTHER REMEDIES ARE EXCLUDED, INCLUDING ANY LIABILITY FOR INCIDENTALS OR
CONSEQUENTIAL DAMAGES.
The Company does not authorize any other person, including persons who deal in The Company's dishwashing machines
to change this warranty or create any other obligation in connection with The Company's Dishwashing Machines.
