La Crosse Technology 308-1711BL User manual

Wireless Weather Station
Model: 308-1711BL
DC:013118

POWER UP
1. Insert 2-AA batteries into your sensor, and 2-AA batteries into
your station.
2. Set time, date, etc.
3. Once the sensor is reading to your station, place sensor
outside in a shaded location.
AA AA
LOW BATTERY INDICATOR
·
·
When battery appears in Outdoor Temperature section, replace
batteries in your outdoor sensor.
When battery appears in Indoor Temperature section, replace
batteries in your station.
AA
AA

SETTINGS
·Hold the TIME/DATE button to enter the settings menu.
·Use the ARROW buttons to adjust and TIME/DATE to confirm.
Year
Month
Date
12/24 Hour
Hour
Minutes
Fahrenheit/Celsius
1.
2.
3.
4.
5.
6.
7.
Note: Weekday sets automatically
when year, month and date are set.
TEMPERATURE ALERTS
Set Alerts:
·Hold the TEMP ALERTS button to enter set mode.
·Use the ARROW buttons to adjust and TEMP ALERTS to
confirm.
Sounding Alerts:
·When alert is ringing, the corresponding alert icon will flash.
·The alert will ring for five seconds every minute, until the
temperature is out of alert range.
·Press any button to stop alert. The alert icon will still show.
Arm/Disarm Alerts:
·Press and release TEMP ALERTS button to select alert.
·Press the UP ARROW button to arm temperature alerts.
·Press DOWN ARROW button to disarm temperature alerts.

OTHER BUTTON FUNCTIONS
Hold TIME/DATE: To enter settings menu. Use the ARROW
buttons to adjust. Press TIME/DATE button to confirm.
Hold ALERTS: To enter alert set mode. Use the ARROW
buttons to adjust. Press ALERTS to confirm.
Press ALERTS: To toggle between high and low alerts.
Press the UP ARROW button to arm an alert.
Press the DOWN ARROW button to disarm an alert.
Hold TIME ALARM: To set alarm time. Use the ARROW
buttons to adjust. Press TIME ALARM button to confirm.
Press TIME ALARM: Once to view alarm time. Press again to
activate or deactivate time alarm. Alarm bell will show when
active.
Press TIME ALARM (when alarm sounds): To silence alarm for
10 minutes.
HEAT/DEW BUTTON: Hold to search for sensor.
Press & release to view Heat Index & Dew Point readings.
Press DOWN ARROW (MIN): To view minimum temperature
readings.
Press UP ARROW (MAX): To view maximum temperature
readings.
Note: The MIN/MAX readings automatically reset daily at 12:00
midnight.

Outdoor Temperature Range: -40°F to 140°F (-40°C to 60°C)
Outdoor Humidity Range: 10%-99% RH
SPECIFICATIONS
Indoor Temperature Range: 32°F to 122°F (0°C to 50°C)
Indoor Humidity Range: 10%-99% RH
Power Requirements: Station-2 AA batteries (not included)
Sensor-2 AA batteries (not included)
Battery Life: Station-over 24 months
Sensor-over 24 months
Dimensions Station- 5.40” L x 1.68” W x 4.40” H
(13.72 cm L x 4.28 cm W x 11.18 cm H)
TX141TH-Bv2- 1.57” L x 0.79” W x 5.12”H
(4.0cm L x 2.0cm W x 13.0cm H)
MOON PHASE
The Moon Phase feature is based on the lunar calendar, and
therefore is controlled by the time and date set on your weather
station.
New Moon Small Waxing
Crescent
Large Waxing
Crescent
First Quarter Small Waxing
Gibbous
Large Waxing
Gibbous
Small Waning
Crescent
Large Waning
Gibbous
Small Waning
Gibbous
Last Quarter Large Waning
Crescent
Full Moon

FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Increase separation between equipment & receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This device must not be co-located or operating in conjunction with any other
antenna or transmitter.
Operation is subject to the following two conditions:
(1 ) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Caution!
The manufacturer is not responsible for any radio or TV interference caused
by unauthorized changes or modifications to this equipment. Such changes or
modifications could void the user authority to operate the equipment.
All rights reserved. This manual may not be reproduced in any form, even in part,
or duplicated or processed using electronic, mechanical or chemical process
without the written permission of the publisher. This booklet may contain errors
or misprints. The information it contains is regularly checked and corrections are
included in subsequent editions. We disclaim any responsibility for any technical
error or printing error, or their consequences. All trademarks and patents are
recognized.
Buy quality RV electronics in our online store.