Laney TI412S User manual

Tony Iommi
TI412S

4

“It began with a clap of thunder and a tolling bell.Then,as a heavily distorted guitar played a
diminished fifth – an interval once banned by the Roman Catholic church for being the Devil’s interval
– a male voice started to wail as if from the grave…… and music was never the same again.”
The date was February 13,1970 and the album was Black Sabbath
by Black Sabbath – the guitarist wasTony Iommi and the distorted
th
diminished 5 sound was a Laney LA100BL.
Since this auspicious day Laney’s association withTony has gone
from strength to strength and now,we are extremely proud to
announce a newTony Iommi Signature Cabinet – theTI412S.
TheTI412S was born out of an exhaustive period of product
development,hand in hand withTony at every stage and the perfect
partner to theTI100 head.
TheTI412S features:
There are very few chances in life to claim a first,many
people can claim to be the biggest or the fastest but only one
person can claim to be the first.In the case of Heavy Metal
…….the first Heavy Metal guitar tone was crafted byTony
Iommi and powered by Laney.
rugged plywood construction,Celestion
Heritage G12H (75) drivers,black metal corners,castors,castor
cups,comfortable steel side bar handles,rubber feet - finished in
Tony's trademark livery.
Best wishes from all at Laney.

In order to take full advantage of your new product and enjoy long and trouble-free performance,please read this owner's manual
carefully,and keep it in a safe place for future reference.
1).Unpacking:On unpacking your product please check carefully for any signs of damage that may have occurred whilst in transit
from the Laney factory to your dealer.In the unlikely event that there has been damage,please repack your unit in its original carton
and consult your dealer.We strongly advise you to keep your original transit carton,since in the unlikely event that your unit should
develop a fault,you will be able to return it to you dealer for rectification securely packed.
2).Amplifier Connection: In order to avoid damage ,it is advisable to establish and follow a pattern for turning on and off your
system.With all system parts connected,turn on source equipment,tape decks,cd players,mixers,effects processors etc,BEFORE
turning on your guitar amplifier.Many products have large transient surges at turn on and off which can cause damage to your
speakers.
By turning on your guitar amplifier LAST and making sure its level control is set to a minimum,any transients from other equipment
should not reach your loud speakers.Wait till all system parts have stabilised,usually a couple of seconds.Similarly when turning off
your system always turn down the level controls on your guitar amplifier and then turn off its power before turning off other
equipment
3).Cables: Never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle
the amplifier load and could cause damage to your complete system.
4).Servicing:The user should not attempt to service these products.Refer all servicing to qualified service personnel
6

UNPACKING INSTRUCTIONS TI412S
1. Open the top of the carton, remove the top foam tray, side
protectors and open the protective bag, pull back to sides.
2. Flip the carton over. Cabinet now rests on its castors.
3. Remove the carton, bottom foam tray and protective bag.
4. Enjoy.
16 Ohms
Link
Power Rating
120W
Input
Made in the UK by Laney
Serial Number:
www.laney.co.uk
Tony Iommi
L ZB 1 2 3 4
TI412S
TI412S
Weight 48Kg Packed 51Kg
Impedance 16 Ohms
Drivers 4 x 12" Celestion Heritage G12H (75) Driver
Power RMS 120 Watts
Inputs 2 x 6.3 Jack sockets
Overall
Dimensions W 771 x H 756 x D 358
Cabinet
Design Rugged plywood construction, black metal corners, castors, castor cups, comfortable steel side bar
handles, rubber feet - finished in Tony's trademark
livery.
7

OPERATING INSTRUCTIONS Issue 1.0