www.lanpro.com
Active Products - Cameras - LP-512
In order to reach the electronics, remove the back cover by removing three (3) screws, one (1) on the top (gure 1) and
two (2) on the button (gure (2).
One open (gure3), please locate the reset push-button with a white plastic push as shown in gure 4
1
2
Figure 1
Reset camera to factory values (Reset)
Turn the camera on by pluging in the power connector. Then
push the reset push button for 30 seconds as shown in
gure 5
3
Figure 3
Figure 6
Figure 5
Figure 2
Figure 4
For closing the camera again, place the three (3) screws
again, as shown in gure 6
4
