Larson Electronics GLS-PMK User manual

GLS-PMK
Larson Electronics, LLCPhone: [phone] Fax: [phone]www.larsonelectronics.com
1of 3
Golight Stryker Permanent Mount Assembly - Converts Magnetic
Mount Golights to Permanent Mount
Instruction Manual
1. $VVemble together a Phillips head screwdriver,
your permanent mount kit / assembly, and a pair of
wire cutters.
2. Remove the screws that hold the magnetic base to
the Golight.
3. To fully remove the base you will need to cut the
wire as close to the butt connectors as possible.
Pull the cable out and remove the base.
4. Pull the cable out from the back of the Golight.
5. Apply the rubber seal.
6. Add the two base brackets and replace the screws
securing the brackets in place.
7. Add the mounting plate and secure with a screw.
8. Use a pair of butt splices to reconnect wiring as
necessary.

Larson Electronics, LLCPhone: [phone] Fax: [phone]www.larsonelectronics.com
2of 3
GLS-PMK
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER
INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT [e-mail] OR BY PHONE AT
1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURNINFORMATION.
For a video instruction click here or scan the qr code below.
For a instruction on how to permanently mount your Golight click here or scan the qr code below.