TAKING PHOTOS
Always use fully charged batteries for best performance. Load the batteries and hold down
the shutter button until the power-on beep is heard. “000” will display in the LCD. Use the
optical viewfi nder. Hold the camera steady while pressing the shutter button. A beep will
indicate a photo has been taken. When the camera is full and you press the shutter button a
continuous beep will sound.
Tips
When taking photos, a quiet beep sound will indicate errors, such as low batteries. Other
conditions such as lighting will also affect picture quality.
CAMERA FUNCTION CONTROL
> Delete single photos: Press the function button until indicated this mode is on the LCD.
Press the shutter button once within 5 seconds to delete the last photo taken.
> Delete all photos: Press the function button until this mode is indicated on the LCD. Press
the Shutter Button once within 5 seconds to delete all the photos stored in the camera.
PHOTO RESOLUTION SELECTION
Resolution status will be shown on the LCD display in small characters. You may select
between ‘”Hi” and “Lo” resolution. “Hi” SXGA mode 1280*960 pixels and “Lo” VGA 640*480
pixels. To switch between “Hi” and Lo” use the function button. Hi mode will allow approx 30
photos and Lo mode about 104 photos.
PHOTO STORAGE
The LCD display will always show the resolution status and number of photos taken unless the
Select button is pressed. Note: Each time you change the resolution, the number of photo you
have taken will not change
PC TRANSFER
Connect your camera to your PC
via USB cable. A beep will sound
once connected.
Install Driver from CD, then run it
from Start > Program > MyDSC2,
to access photos
Or Install Photo Impression
4 from CD, then run it from
Start > Program > ArcSoft
Photo Impression. Then click
“Get photo”, click “Camera/
Scanner” to get photos
