Last Chance Archery Ultra Lock Adapter User manual

Ultra Lock Adapter
Product warnings and instructions
Parts Included:
• Left bracket • Right Bracket

READ ALL INSTRUCTIONS BEFORE INSTALLATION
AND USE OF YOUR ADAPTER SET.
http://lastchancearchery.com/videos/
Visit the link above, or by scanning the QR code
above, for a detailed instructional video on the
Ultra Lock Adapters assembly and use.
Ultra Lock Adapters MUST ONLY be used on Last
Chance Archery, LLC built bow presses and will not
be warrantied for use on any other press.
The Ultra Lock Adapter is designed and tested for
pressing the Hoyt Ultra Flex Limb system™ only.
Using the ULA on any other bow types will be at the
owner’s own risk; and LCA can not be held
liable for injuries or damages caused by
pressing any other bow type.
Press springsteel is sharp and can cut your hand
while installing ULA, be cautious.
WARNINGS:
Disassembly, modications and/or tampering of any kind, to
any LCA product, will void all warranties.

Step #1. Remove your adapters
from the box and check to be
sure all parts are included. Upon
removal from the box, you’ll notice
the adapter set is fully assembled
and ready to go.
Step #2. Check your LCA nger
block screws to be sure they’re
tight, then read all warnings and
cautions before using your Ultra
Lock Adapter set to avoid injuries
or damage to your bow.
Step #3. Take the right bracket of
your ULA set and attach it onto the
LCA nger block.
(as shown in steps A,B,C).
Step #4. Take the left bracket of
your ULA set and attach it onto the
opposite LCA nger block. Be sure
that the brackets seat rmly onto
the LCA block pin (C).
WARNING: Spring Steel is Sharp, Use Caution.
A. B.
C. D.
The ULA is equipped with a compression spring to keep all the
parts tight and solidly in place for ease in use (D).

LAST CHANCE ARCHERY, LLC
619 Hubert Pittman Rd
Pendergrass, GA 30567
Customer Service: 706-654-1961
or [e-mail]
Step #5. Once your ULA brackets are securely attached to your
press. You can press the bow by putting the limbs inside the left
adapter rst (A). This will make the bow easier to manage while
you then t the bow into the right adapter (B) using the press
wheel or actuating press motor (D). Move the press in slowly as
to insure proper t and alignment (as shown in steps A,B,C,D).
Step #6. Note that the ULA rollers are supposed to touch the
limbs of the bow when being pressed. These rollers are
designed and engineered to touch the limb precisely to
lock the bow into place once pressure is applied (C).
A. B.
C. D.