LattePremio LP-15 User manual

LATTEPREMIO
LP-15 | LP-16
Bedienungsanleitung
Operating Instructions
Notice d’utilisation
Gebruiksaanwijzing
D
GB
F
NL

Important safeguards
When using electrical appliances, in order to
reduce the risk of re, electric shock and/or injury,
these basic safety precautions should always be
followed:
• Read all instructions
• Do not touch hot surfaces. Use handles or knobs.
• To protect against electrical shock; do not im-
merse cord, plug or any part of the milkfrother in
water or other liquid.
• Close supervision is necessary when it is used by or
near children.
• Unplug unit from outlet when not in use and before
cleaning, allow to cool before putting on or taking off
parts and before cleaning the appliance.
• Do not operate any appliance with a damaged
cord or plug, after the appliance malfunctions, or
has been damaged in any manner. Return appli-
ance to the nearest authorized service facility for
examination, repair or adjustment.
• The use of accessory attachments not recom-
mended by the appliance manufacturer may result
in re, electric shock or injury to persons.
• Do not use outdoors.
• Do not let the cord hang over edge of table or counter,
or touch hot surface.
• Do not place on or near a hot gas or electric burner, or
in a heated oven.
• Always attach plug to appliance rst, then plug cord
into the wall outlet. To disconnect; turn off the switch
then remove the plug from the outlet.
• Do not use the appliance for other than its intended
use.
• Make sure that your outlet voltages correspond
to the voltage stated on the rating label of the
milkfrother.
• Do not use the milkfrother with a damaged outlet.
• Any examination, repair, or adjustment for the
appliance should be made by the authorised
service agent.
• If the power cord is damaged, it must be re-
placed by the manufacturer or its service agent or
similar qualied person in order to avoid danger.
• Save this instruction manual for future use.
Foremost BV is not responsible for any damages to
the appliance, caused by:
• Heat chamber- water scale build up
• Use of inappropriate anti-calcium detergents
• Use of inappropriate cleaning detergents
• The use not according to the Instruction manual
• The use of expired milk or any other beverages than
milk
The warranty shall not apply if:
• The model and/or serial number on the product has
been altered, removed or is unreadable.
• Repairs, modications or adjustments are made by
any other than authorized dealers
• The product is being used for commercial purposes or
other than approved.
• The defect is caused by abuse, misuse or by local
conditions installation/usage not in accordance with
the recommendations for the operation of the product.
• The damage is caused by accidents as lightning,
ickering, fall, voltage, ooding, re, natural disasters
or accidents.
• The damage is caused by animals.
• The product malfunctioning due to normal wear of
parts / components
• The product doesn’t work properly because it was
not originally developed / engineered / manufactured,
approved and/or authorized for the country/area
where it is being used
• If it has been purchased in another country.
• Normal cleaning not according to instruction, in term
of frequency and method. Cleaning of parts not in the
appropriate method
• Use of inappropriate milk and milk not in the correct
temperature for the appliances.
• No performance due to inappropriate use of the appli-
ance

Appliance description
Table of Contens
Appliance description 0
Before the rst use 0
Daily, before use 0
Preparation 0
Cappuccino 0
Caffe Latte / Hot milk 0
Latte macchiato 0
Increasing capacity 0
Programming the ll up level / default time 0
Heating 0
Frothing 0
Reset to factory settings 0
Energy saving mode 0
Protection function 0
Cleaning the Appliance 0
Before the cleaning process 0
Cleaning programs 0
Descaling 0
Decalcication 0
Troubleshooting 0
Storage / Disposal 0
Techincal data 0
Watertank
(max. 600 ml)
Power cord connector
ON/OFF switch
Removable front head
Milk outlet
Milktank
(max. 600 ml)
Drip grid
Drip tray
Cleaning
container
Accessoires
Extension
hose
Froth
head
Dear customer,
By purchasing the LattePremio Milkfrother, you have chosen for quality, technology and functionality.
Please read this information thoroughly to become quickly familiar with the milk frother,
enabling you to fully enjoy its functions.
Your appliance will serve you many years if properly cared for and maintained.
We hope you enjoy your LattePremio milkfrother.

3
1
2
Before the rst use or after a longer period of non-use
Daily, before use
Fill water tank with fresh
water (max. 600 ml)
Fill water tank with fresh
water (max. 600 ml)
Heating up
Heating up
Ready
Ready
Place cleaning cup
Fill milk tank with cold fresh
milk (min. 200 ml / max. 600 ml)
Plug into mains & switch
the appliance on
Switch the appliance on
Run cleaning program
(see chapter: cleaning)
NOTE
• Do not use sparkling water or distilled water in watertank. Use ordinary tapwater, or still bottled water when
living in a hard water area.
• Do not place the appliance in direct sunlight, near oven or other hot surfaces to prevent the milktemperature in
the milktank to increase.
NOTE
• Milk must be stored in the refrigerator at 4°C before use.
• In order to keep the milk fresh we recommend to refresh the milk in the milktank every hour.
• For best frothed milk performance we recommend to run the appliance once in frothing function with milk in
order to remove any air and water out of the frothhead
NOTE
• If not in use: store milktank into refrigerator
• Temperature: Hot milk: 47-52 °C, Milkfoam: 65 °C
Preparation
Cappuccino Caffe Latte / Hot milk
Latte Macchiato
Increasing capacity
Place cup on drip tray
Replace high driptray
for low drip tray
Attach extension hose Place extension hose in
external container /
milkcarton
Remove front cover
Place a Macchiato glass
underneath the milk outlet
Press button B
Press button B Place cup on drip tray Press button A

34 6
7
5
Programming the ll up level / default time
Heating (default time 30 sec. / 150 ml hot milk)
Energy saving mode
• After 5 minutes of NON using the appliance, the appliance will automatically switch into energy-saving mode.
The buttons will light up alternately.
• By pressing either one of the buttons, the appliance will resume in normal function mode.
• The energy-saving mode time can be changed from 5 minutes (factory default time) to 30 minutes.
- For 5 minutes setting: press and hold button A and switch on power untill all buttons light up.
- For 30 minutes setting: press and hold button B and switch on power untill all buttons light up.
Frothing (default time 20 sec. / 100 ml foam & milk)
4.3 Reset to factory settings
Press A for approx.
3 seconds until it ashes
Press B for approx.
3 seconds until it ashes
Press both buttons
simultaneously for
3 seconds
Press A again to set
the cup volume
Press B again to set
the cup volume
Setting range cup
volume 5 - 60 seconds
Setting range cup
volume 5 - 60 seconds
5 sec 60 sec
5 sec 60 sec
Start Stop
StopStart
Cleaning the appliance
Before starting the cleaning process
Protection function
• The CLEAN button will ash fast when the front cover or the milktank will be removed from the appliance.
This appliance has two cleaning programs: short clean & long clean
The application is as follows:
Fill water tank with fresh
water (max. 600 ml)
Press the button once for
a short program
(30 seconds)
Take out the milktank and
place cleaning cup
Hold the button for
> 2 sec. to start a long
program (60 seconds)
Fill the milktank with
water for thorough
cleaning (min. 200 ml /
max. 600 ml)
30 sec 60 sec
Long clean x2 Short clean
• Before the rst use
• After long periode of non-use
• When appliance not in use
• At the end of the day after use
• Before the rst use every day
• Between each cups if there is an interval time of more
than 30 minutes.
NOTE
• It is recommended to clean the front cover and
the froth head in water after the LONG CLEAN
program, for hygenic purposes. The milk tank
and suction pipe must be cleaned after use.
It is recommended to immerse them in warm wa-
ter overnight.
Cleaning the outside of the appliance
• Remove the plug from the outlet before cleaning the appliance.
• Wipe outside with a soft, dry cloth, after the appliance is cooled down. Never use metal polish!
• The removable items are NOT dishwasher safe

6
7
9
11
10
8
Descaling
NOTE
• Run decalcication every 3 months or after 300 cycles.
• Start the decalcication program only when the appliance is cold (Appliance will not start if its hot)
Preparation
Switch of the appliance
and remove all accesoiries
Fill water tank and add
descaler to recommended
ratio on box
Place large glass or
container underneath
the milkoutlet
Decalcication
Hold down the clean but-
ton and switch on power
untill all buttons light up
Switch appliance off,
remove water tank and
froth head
When CLEAN button
lights up the appliance
is ready for decal cycle.
Press CLEAN button
Clean the water tank
and froth head under
tap water
Clean and rell water
tank* (keep appliance
switched on)
Attach froth head
and cleaning cup and
switch appliance on
Press CLEAN button
for 5 min. run with tap
water. Run 2 times
Run the ‘Long clean‘
program at least 2
times. After this the ap-
pliance is ready for use
NOTE
• * Make sure there is no descaler left in water tank
2x 5 min.
2x 60 sec.
Troubleshooting
Faults Possible cause Repairs
Indicator lights do not ash after
switching on the appliance
Plug not in socket or power cord
connector
Connect plug
No milk ow • Water tank empty
• Front cover not attached properly
• Suction pipe from milk tank lid
not assembled
• Fill water tank
• Attach front cover
• Connect suction pipe to lid from
milk tank
Button B ash fast • The appliance is overheated • Switch appliance off untill it is
cooled down. Then switch on
again. If button B still ashes fast
contact service center.
Button A ash fast • Environment is too cold.
Less than 5 degree °C
• Place the appliance to room temp
environment. If button A still a-
shes fast contact service center.
NOTE
• If you cannot solve the problem following the steps outlined above, please contact the customer service.
Technical data
Dimensions (H x B) 254 x 361 mm
Approx. weight 3,3 kg
Operating voltage 220-240 V
Frequency 50 - 60 Hz
Power consumption, max. 1000 W
Length of cable 1,5 m
Watertank 600 ml
Milktank 600 ml
Storage / Disposal
If you do not need the appliance for an extended period of time, allow it to cool down and clean the appliance
as described in the chapter Cleaning and Care to prevent mould formation. Mould fungus represents a health
risk and stains may develop on the unit which can no longer be removed. Electric and electronic end-of-life
appliances often still contain valuable materials. However, they also contain hazardous substances which
were required for their proper function and safety. If disposed of with regular household waste or treated
incorrectly they can pose a risk to human health and the environment.
NOTE
• Use the collecting station in your municipality to return electrical and electronic end-of-life appliance for
recycling. Obtain the information required, if necessary, from your city hall, your waste disposal company
or your dealer.
• Render the appliance unusable before disposal. Make sure your end of life appliance is stored safely away
from children until hauled away.

Datum / Date:
We reserve the right to make techincal changes, we are not liable for any erros or printing errors
Stamp and signature of dealer