Connection Kit
LPS II
Quick start guide
V 2
Safety
This Quick Start Guide will help you to handle the LPS II connec-
tion kit safely. Use the connection kit solely in accordance with its
intended use:
Use the connection kit exclusively for connecting (DC charging) an
LPS II in the vehicle.
Observe the safety instructions:
WARNING!Risk of injury from electric shock due to short-cir-
cuit currents. Disconnect the negative cable of the vehicle battery
before installation.
Technical Data
Part no.: 1051009003
Modell LPS II Connection Kit
Weight 2.18 kg
Package Contents
No. Name
2 x Connection cable (4 m, H07V-K 16 mm²), one side with
tubular cable lugs, M8
1 x Signal cable (4 m, H05V-K-1; 1.0 mm²) with fuse holder
and flat fuse (3A)
1 x Fuse holder with strip fuse (80A)
2 x Terminal cable lug
3 x Insulating cap, red
1 x Insulating cap, black
1 x Corrugated pipe (3.7m)
Installation
WARNING!Risk of injury from electric shock due to short-cir-
cuit currents. Disconnect the negative cable of the vehicle battery
before installation.
NOTE!Ensure that the LPS II is switched off during installation.
To connect the LPS II to the vehicle battery, perform as follows:
1. Disconnect the vehicle battery from the on-board power supply.
2. Protect the positive cable for the DC input as close as possible to
the vehicle battery with a suitable fuse (80 A).
3. Connect the positive cable for the DC input to the positive ter-
minal of the vehicle battery.
4. Connect the negative cable for the DC input to the negative ter-
minal of the vehicle battery.
5. Connect the cable ends with the tubular cable lugs of the positive
and the negative cable to the respective screw terminals for the
DC input (12 V) on the unit and screw them tight.
6. Connect a signal cable (1 mm²) to the vehicle's D+ signal (ter-
minal 61), alternatively to terminal 15.
NOTE!When connected to terminal 15, the charge booster is per-
manently active when the ignition is switched on. This can lead to
discharge of the vehicle battery.
7. Protect the signal cable near the connection on the vehicle with a
suitable fuse (1 A ... 3 A).
8. Connect the tubular cable lug of the signal cable to the C1 ter-
minal on the rear of the unit.
9. Connect the vehicle battery to the on-board power supply.
ðThe LPS II is connected.
Disposal
Dispose of the device in accordance with the Waste
Electrical and Electronic Equipment Regulations
(WEEE).
The system must not be disposed of with household
waste. Take it to a recycling point or return it to your
point of sale.
EU Declaration of Conformity
The LPS II Connection Kit complies with the require-
ments of the following directives:
– 2011/65/EU: RoHS
LEAB Automotive GmbH
Thorshammer 6
DE-24866 Busdorf
Tel: +49 (0) 4621 9 78 60-0
Fax: +49 (0) 4621 9 78 60-260
It is prohibited to copy, duplicate, translate or otherwise
pass on the content of this guide to third parties without the
express written permission of LEAB.
We make energy mobile.
