Leading Solutions Tab Secure Flex User manual

Tab-Secure - Flex
Assembly Instructions
Tools you will need:
a b cdef
a
b
c
d
e
f
Pencil
Drill
16mm Drill Bit
6.5mm Drill Bit
Spanner
Phillips Screwdriver
Tool key:
1
Components key:
Tablet Case
2
3
4
5
Flex Stalk
M5 x 25mm Buttonhead Screw x4
M5 x 50mm Threaded Rod x4
Washer Plate x2
1
2
8
7
4
6Keys
5
1
Drill the mounting holes into
your surface using the washer
plate as a template.
Tip: Use a smaller drill bit to
drill a pilot hole.
7 M5 Countersunk Screw x 4 7
6 M5 Hex Nut x4
88
3

2Attach the rotating base component to
the stalk using the button head screws.3Attach the threaded rod to the bottom of the rotating base.
4Thread the power cable through through the stalk.5Attach the stalk to your surface.
6Place the washers and nuts onto the
threaded rod and tighten. 7Attach the tablet case to the stalk using the steel washer and nuts.

8Place the iPad in the holder and plug
the power cable in. 9Remove the protective brown paper from the faceplate.
10 Place the faceplate on top of the iPad. 11 Cover with the metal faceplate and push the
button on the key barrel to lock the unit.
Installation Guidelines:
To minimise the glare on the
screen, avoid installing the
iPad directly below a source
of light.
Maintenance of your iPad kiosk:
To keep the display looking its best,
clean regularly with screen wipes.