Ledvance PHASE EV EVCSBSMTGPLATE User manual

Page 1of 6
LEDVANCE PHASE EV
Installation Guide
Side-by-side Mounting Plate
Item No: 78137
Model: EVCSBSMTGPLATE
Side-by-side mounting plate for use with
EVC48ALVL2C1XX (Level 2 Commercial EVSE) and
EVCPED (pedestal).
WARNING
−TO PREVENT PERSONAL INJURY OR PRODUCT DAMAGE ONLY LICENSED ELECTRICIANS SHOULD
PROVIDE ALL INSTALLATION SERVICES.
−TO AVOID ELECTRIC SHOCK OR COMPONENT DAMAGE DISCONNECT POWER BEFORE ATTEMPTING
INSTALLATION OR SERVICING.
−THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE NATIONAL ELECTRIC CODE (NEC)
AND ALL APPLICABLE FEDERAL, STATE AND LOCAL ELECTRICAL CODES AND SAFETY STANDARDS.
−ANY ALTERATION OR MODIFICATION OF THIS PRODUCT IS EXPRESSLY FORBIDDEN AS IT MAY
CAUSE SERIOUS PERSONAL INJURY, DEATH, PROPERTY DAMAGE AND/OR PRODUCT MALFUNCTION.
−TO PREVENT PRODUCT MALFUNCTION AND / OR ELECTRICAL SHOCK THIS PRODUCT MUST BE
PROPERLY GROUNDED.
Please Read All Instructions Before Attempting Installation

Page 2of 6
Safety Precautions
IMPORTANT:
READ CAREFULLY BEFORE INSTALLING THE SIDE-BY-SIDE MOUNTING PLATE. RETAIN FOR
FUTURE REFERENCE.
GENERAL:
Upon receipt of the side-by-side mounting plate, thoroughly inspect for any freight damage which should
be brought to the attention of the delivery carrier.
What’s Included
- (1) Side-by-side mounting plate
- (1) Panel cover
- (14) M5*12mm screws
Tools You Will Need
- Phillips screwdriver
- Wire cutter & stripper
- Crimping pliers

Page 3of 6
Side-by-side (SBS) Mounting Plate Installation
1. Remove the back 2 cover panels by unscrewing the 12 screws.
2. Next, attach the SBS mounting plate to the
pedestal with (10) M5 provided screws.
Attach SBS mounting
plate with (10) M5 screws

Page 4of 6
3. Install the holsters, cable hangers, and front panel cover.
Install front
panel cover.

Page 5of 6
4. Install charger mounting plate and charger as shown in the pictures below. Repeat for both sides.

Page 6of 6
5. Feed the wirings through the holes on each side and make the connections. When finished, install the
back plates and the back panel cover.
Feed wirings through
hole on each side.
Install back plates and
back panel cover.