Leem KT Series User manual

CH 2
CH 1CH 1
CH 1
CH 2 CH 2
220V~50/60Hz 150W CH 2 CH 1
LOCK
OUTPUT
RESET SENSITIVITY MODE
1.4V
0.775V BRIDGE
STEREO
INPUT
CH2
INPUT
CH 1
LOCK
BRIDGE
KT series
Power amplier
USER MANUAL

◊ Ventilation : Do not block areas of ventilation opening.
Failure to do could result in fire. Always install
accordance with the manufacturer’s instructions.
◊ Object and Liquid Entry : Objects do not fall into and
liquids are not spilled into the inside of the apparatus for
safety.
◊ Power Cord and Plug : Protect the power cord from
being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit
from the apparatus. Do not defeat the safety purpose of
the polarized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A ground-
ing type plug has two blades and a third grounding
prong. The wide blade or the third prong is provided for
your safety. If the provided plug does not fit into your
outlet, refer to elec-trician for replacement.
◊ Power Supply : The apparatus should be connected
to the power supply only of the type as marked on the
apparatus or described in the manual. Failure to do
could result in damage to the product and possibly the
user. Unplug this apparatus during lightning storms or
when unused for long periods of time.
The symbol is used to indicate that
some hazardous live terminals are
involved within this apparatus, even
under the normal operating conditions,
which may be sufcient to constitute
the risk of electric shock or death.
The symbol is used to indicate that
some hazardous live terminals are
involved within this apparatus, even
under the normal operating conditions,
which may be sufcient to constitute
the risk of electric shock or death.
WARNING Describes precautions that should be
observed to prevent the danger of injury or
death to the operator.
CAUTION Describes precautions that should
be observed to prevent danger of the
apparatus.
◊ Read these instructions.
◊ Keep these instructions.
◊ Heed all warning.
◊ Follow all instructions.
◊ Water & Moisture
◊ The apparatus should be protected from moisture
and rain, can not used near water, for example:
near bathtub, kitchen sink or a swimming pool,
etc.
◊ Heat
◊ The apparatus should be located away from the
heat source such as radiators, stoves or other
appliances that produce heat.
◊ Fuse
◊ To prevent the risk of re and damaging the unit,
please use only of the recommended fuse type
as described in the manual. Before replacing
the fuse, make sure the unit turned off and
disconnected from the AC outlet.
◊ Electrical Connection
Improper electrical wiring may invalidate the
product warranty.
◊ Cleaning
Clean only with a dry cloth. Do not use any
solvents such as benzol or alcohol.
◊ Servicing
Do not implement any servicing other than those
means described in the manual.
Refer all servicing to qualied service personnel
only.
◊ Only use accessories/attachments or parts
recommended by the manufacturer.
IMPORTANT SAFETY INSTRUCTIONS

►This amplier only can plug in the AC power socket
which the user's manual instructs or the specica-
tion is shown on this adapter. Or else it may damage
the amplier and cause a re or electric shock.
►Do not place heavy objects (including this amplier)
on the power cord, or else it may damage the power
cord and then cause an electric shock or re.
►Do not expose the amplier in the fume, high
humidity, high temperature and dust accumulation
place and use.
►Do not put this amplier sidelong or upside down,
use it in a good air ow environment.
►When abnormity happen in the operation process,
such as smoke, odor, noise, or foreign bodies, liquid
entering into the amplier, please turn off the ampli-
er immediately, and unplug the socket from the AC
power socket
►The device shall not be exposed to dripping or
splashing, shall not be placed the item which is
lled with liquids on the device, such as vase and
so on.
►When the device is connected to the power supply
socket, it needs the ground protection.
►The socket of the power cord needs to keep in the
normal operational condition.
►If need to completely disconnect this device from
the AC main line, please unplug from the AC power
outlet, when you need to power on, please plug in
the AC power outlet again.
►When abnormity happen, please don't open the
chassis and rebuilt or repair the amplier by
yourself, if the internal is sure to need repair and
maintenance, please contact the dealers to deal
with it.
1. When the speaker is connected to the amplier
output socket, it only can use the speaker
special cable and connect it in accordance
with the provisions.
2. When connect the amplier, please close
all the instruments, audio equipments and
speakers.
3. Before turning on the amplier, please turn
down the volume to a minimum.
4. If you do not use this amplier for a long time,
please unplug the power cord from the AC
mains socket.
5. When unplug the power plug from the AC
power socket, please grasp the plug. Do not di-
rectly pull the cable. Otherwise it can damage
power cord and then lead to a re or electric
shock.
IMPORTANT SAFETY INSTRUCTIONS

CH 2
CH 1CH 1
CH 1
CH 2 CH 2
220V~50/60Hz 150W CH 2 CH 1
LOCK
OUTPUT
RESET SENSITIVITY MODE
1.4V
0.775V BRIDGE
STEREO
INPUT
CH2
INPUT
CH 1
LOCK
BRIDGE


CH 2
CH 1CH 1
CH 1
CH 2 C H 2
220V~50/60Hz 150W CH 2 CH 1
LOCK
OUTPUT
RESET
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK,
GROUNDING OF THE CENTER PIN OF THE PLUG MUST BE
MAINTAINED.
SENSITIVITY MODE
1.4V
0.775V BRIDGE
STEREO
INPUT
CH2
INPUT
CH 1
LOCK
BRIDGE
Parallel connection
2+
1-
2-
1+
Horn:
+to PIN 1+
Horn:
- to PIN 1-
A
+
-
B
+
-
A
CH 2
CH 1CH 1
CH 1
CH 2 C H 2
220V~50/60Hz 150W CH 2 CH 1
LOCK
OUTPUT
RESET
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK,
GROUNDING OF THE CENTER PIN OF THE PLUG MUST BE
MAINTAINED.
SENSITIVITY MODE
1.4V
0.775V BRIDGE
STEREO
INPUT
CH2
INPUT
CH 1
LOCK
BRIDGE
Bridge connection
2+
1-
2-
1+
Horn:
+to PIN 1+
Horn:
- to PIN 2+
A
+
-
A
CH 2
CH 1CH 1
CH 1
CH 2 CH 2
220V~50/60Hz 150W CH 2 C H 1
LOCK
OUTPUT
RESET
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK,
GROUNDING OF THE CENTER PIN OF THE PLUG MUST BE
MAINTAINED.
SENSITIVITY MODE
1.4V
0.775V BRIDGE
STEREO
INPUT
CH2
INPUT
CH 1
LOCK
BRIDGE
Stereo connection
A
B
2+
1-
2-
1+
Horn:
+to PIN 1+
Horn:
- to PIN 1-
A
+
-
B
+
-


LEEM products are warranted free from defects in materials and workmanship for a period of 1 year
from date of purchase if used under normal operating conditions. Products will not be warranted if the
serial number is removed or defaced. LEEM , through the applicable authorized distributor, will repair or
replace defects covered by this limited warranty with parts or products of original or improved design,
at its option, for products purchased. If your LEEM product ever needs service, write or telephone us at
Technical Service Department (TEL: +82-32-815-1793) between normal business hours, excluding
weekend. Then you will be directed to send the product to LEEM or an authorized agency you purchased
at your expense. This warranty contemplates the owner will reasonably maintain this instrument or product
without alteration, negligent use, misuse, or abuse. Normal wear and tear of this product will not be
covered by this or any implied warranty.
• The repairing during the warranty period will not be charged whenever the buyer shows that they are
the original ones, by presenting the original invoice duly made by the retailer together with the
warranty certificate including all the required details.
• We establish that this warranty loses validity in the following cases:
»In case that the unit is not used at the proper voltage (higher or lower than usual)
»If the product has been damaged due to wrong usage or handling
»If the product shows signs that a non-official technician has repaired it or if the original parts have
been replaced.
• This warranty will automatically be finished in the following cases :
»Damages caused by strokes during the
transportation after loading.
»Damages due to robberies or accidents
(Fire, Flood, etc)
• The user must have this warranty card
together with the invoice (he must not
send or give them to anybody) in order to
show them to any of our Authorized Technical
Service offices, whenever the product needs
to be repaired during the warranty period.
• This certificate has only validity in the conutry
where the product has been purchased.
• Our authorized Technical Service will evaluate
if the conditions of the warranty have been
fulfilled.
LEEM PRODUCT CO.,LTD.
118B-6L, 148(Kojan-Dong) Neungheodae-ro 595beon-gil Namdong-gu, Incheon, KOREA 21698
TEL : +82-32-816-7100~6 FAX : +82-32-816-7108
WARRANTY CERTIFICATE
Seller.
Model No.
Sales date.
This manual suits for next models
3
Table of contents