Legola 9512 User manual

For Customer Service Call: Page 1 of 4
[phone]
www.viaseating.com
9512- Trapezoidal Work Surface
Assembly Instructions
TRAPEZOIDAL SURFACE
1x
BAG A
4x
Table Bracket
BAG B
4x
M6 X 20mm
BAG C
4x
M6 x 16mm
BAG D
TOOLS INCLUDED
1x
4mm Allen Wrench
1x 1x 1x 1x
Button Support
Bracket Button Nut Plug

For Customer Service Call: Page 2 of 4
[phone]
www.viaseating.com
1. Connect all panels using
metal brackets (sold
separately) as shown.
*see General Panel Assembly
Instructions
2. Connect Table Brackets
(BAG A) to curved panels
using the long 20mm
screws (BAG B) with allen
wrench (included).
NOTE: Some buttons may come
fully assembled.
3. Assemble the Button as
shown.

For Customer Service Call: Page 3 of 4
[phone]
www.viaseating.com
4. Slide Button with Support
Bracket attached into Panel
slots with FLUSH SIDE
FACING UP.
5. Slide the Trapezoidal Shelf
down along the curved
panel allowing it to rest on
top of the Table Brackets
and inside the Button
Support Bracket groove.

For Customer Service Call: Page 4 of 4
[phone]
www.viaseating.com
6. Using the short 16mm
screws (BAG C ) start
all 4 screws BEFORE
tightening any of them
fully.
7. Tighten the screws
fully in the sequence
1-4 shown at right.
CAUTION: Using screws
longer than 16mm WILL
damage the Work Surface!
Legola Trapezoidal Shelf-9512
(shown with 40” Curved Panel)