LEO XSP9-7.5/0.25I User manual

Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11.
STAINLESS STEEL SUBMERSIBLE
SEWAGE PUMP
Instruction Manual
XSP

Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11.
CongratulationsonyourpurchaseofaLEOSubmersibleSewagePump
It is important that you read, fully understand and observe the following
safety precautions and warnings. Careless or improper use of the
machine may cause serious or fatal injury. The user is responsible for
any accidents involving other people or other people’s property.
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or lack
of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand
the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision.
Attention!
If the appliance or the supply cord is damaged, it must be
repaired by manufacturer, its service agent or qualified person-
Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities.
Contact your local government for information regarding the collection
systems available.
Function and feature:
XSP series are the advanced and perfect sewage drainages at present time.
Compared with traditional sewage submersible pumps, the XSP-series is re-designed
the passage of flow and enjoys wider high efficiency areas, can be used whole head
without over-loading, and can safely run under large flow rate with high efficiency; anti-
clogging impeller with big passage designed can transfer sewage with big suspend
solid and long fiber; adopted vortex suction structure and particular casting technique,
so with better draining and anti-corrosiveness performance; widely used for
transferring sewage in hotels, cloaca, construction industry, agriculture, family houses,
etc. It can be automatically turned on and off, if it is assembled with float switch.
Submersible pump with cutter is an ideal machine for draining sewage.
A high-speed rotating cutter is assembled at the inlet hole of the pump, make it easy
to cut off long-fiber and firm sundries contained in the sewage, to avoid the impeller
get blocked by the entanglement. It is suitable for draining sewage in sanitation,
factory, mine and family. The thermal protector inside the pump can automatically shut
down the pump when overheating and overload, to guarantee safe and reliable
operation under hard condition.

Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11.
Condition of usage and specifications
1. Maximum operating depth 5m below water lever;
2. Continuous duty when fluid temperature under +40oC;
3. Value of PH in fluid 4~ 10;
4. Maximum kinematic viscosity: 7X10 7〜23X10 6m2/s;
5. Maximum density: 1.2Xl03kg/m3.
Type
XSP9-7.5/0.25I
XSP12-8.5/0.45I
XSP18-12/0.75I
XSP18-12/1.3ID
Power
250 W / 0,33 HP
450 W / 0,6 HP
750 W / 1,0 HP
1300 W / 1,75 HP
Outlet diameter
1.25”
2”
2”
2”
Q. max
9 m3/h
12 m3/h
18 m3/h
18 m3/h
H. max
7.5 m
8.5 m
12 m
12 m
Max. immersion depth
5 m
5 m
5 m
5 m
Gross weight
10 kg
18.2 kg
20.2 kg
22,8 kg
Package
185x180x380mm
495x263x222mm
540x265x195mm
570x310x245mm
Installation and remark
1. Before installation, must carefully check whether there are some parts damaged
during Transport and stock. For example, whether the cable and plug are in good
condition, and the insulated resistance is above 0.5MI1, otherwise must check the
fault.
2. Check whether the power supply is conformed to the stipulation of nameplate
before installation. Pump must connect with earth to keep safe.
3. Before installation, must check whether the cable and plug is fracked, scratched,
broken, etc. If they are faulty, must consult dealer or technician qualified to replace
them.
4. Using iron thread or hoop to make the outlet and discharge pipe tight, and then
tie a rope on the handle as sling so as to move the pump up and down.
5. Impacting and pressing the cable is absolutely prohibited. Cable cannot be used
for sling. Don't discretionarily drag the cable while the pump is running, to avoid
creepage.
6. The power supply connected with the pump must be assembled with Electricity-
leaking circuit breaker, and the voltage must be controlled within 土15% of the rated
to avoid destroying the motor.
Don't touch and move the pump before cut-off the power to keep safe. Be sure that
the connection part between plug and cable is far from the water.
7. Be sure that the plug and cable are far from the heat, oil and the sharp.

Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11.
Maintenance
1. Often check cable and duly replace the cable if it is found with fault of fracted,
broken etc.
2. After running 2000hrs, please maintenance the pump as per the following steps:
•Disassemble pump: carefully check the spare parts easily worn, for example
bearing, mechanical seal, oil seal, “O-ring” , impeller etc. And duly replace
the spare parts damaged.
•Chang oil: take the charge plug of oil chamber out, and inject 10# oil to 70%-
80% of the capacity of chamber (edible earthnut oil is available if no 10# oil).
•Air testing: After maintenance, the pump must be tested by air. Inject high-
pressure air into the pump and keep the pressure at 0.2Mpa, it proved to be
reliable if no leakage within 5 Minutes.
•Don't submerge the pump into the water if it isn't started for a long time. Must
take the pump out of the water and clean it and then make anti-rust processing
Troubleshooting
Symptom
Cause
Corrective action
Pump does not
start
1. Too low voltage
2. Impeller blocked
3. Stator winding burn up
4. Capacitor damaged
5. Absent phase (3
phase)
6. Too large resistance of
cable.
1. Adjust voltage to ±15% of
the rated
2. Remove obstacles
3. Repair
4. Replace capacitor
5. Check switch and cable
connection etc.;
6. Use the proper cable
(Item 3 and 4 must be operated
under the guidance of dealer or
technician qualified.)
Pump
delivers
reduced
water
1. High delivery head
2. Filter mesh clogged
3. Impeller worn off
4. Too shallow
submersible depth
5. Wrong rotation (3
phase).
1. Lower the head
2. Glean the filter mesh
3. Replace impeller
4. Adjust the submersible
depth above 0.5m
5. Inverse two phase.
Pump
stops
suddenly
1. Switch cut off or
blowout
2. Impeller blocked
3. Stator winding burn up.
1. Check power supply,
replace fuse
2. Shut off power, clean
obstacles
3. Repair (must consult the dealer
and technician qualified).

Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11.
Guarantee terms
Please carefully retain the guarantee card completed by the seller, or the proof
of purchase.
Pre-conditions for the 24-month guarantee entitlement:
- Deployment of the device solely for private use.
The guarantee is reduced to 12 months in the commercial sector or leasing
business.
- Proper handling and observance of all information given in the operating manual,
which forms part of our guarantee terms.
- Observance of the prescribed maintenance intervals
- No unauthorized alteration of the design.
- Presentation of the completed guarantee card and/or proof of purchase.
Any guarantee claim shall be immediately void in the event of unauthorized
repairs. Faults and defects, which can be traced to material or manufacturing
faults will be rectified exclusively by our contracted workshops (the seller has
the right to remedy a defect) in your vicinity or by the manufacturer if the latter
is closer. Any claims going beyond the provision of a guarantee are ruled out.
Any transport damage should be reported not to us but to the shipper in
question since, otherwise, any compensation claims the shipper would be
voided.
Information concerning the packaging materials
The used packaging materials must be thrown into the relevant waste collector.
In case of the need of any parts, questions or service instructions please
contact:
 [email protected]
 [phone]
Acquaer Ltd., 4900 Fehérgyarmat, Szatmári u. 11 certifies CE conformity of the
above-mentioned product and that it complies with the technical data specified in the
data plate and the “Operating instructions”.
You can get detailed information about the CE declarations at: www.gamagarden.eu