Leon FLSH User manual

FLSH Bracket
1/8” Depth On-wall Bracket
NOTE: Not all parts in the Wall Mount Kit will be used during install
4x 2x4x 2x
Trusshead ScrewBonded Washer Flip ToggleWood Screw
WALL MOUNT KIT
NOTE: Template may look different based on speaker style. The template for the Horizon Speaker is shown.
FLSH BRACKET PARTS
1x
Template
2x
Wall Plate

FOR ASSISTANCE, CALL: 1.888.213.5015 | MON-FRI 8AM-6PM EST
715 W. ELLSWORTH RD | ANN ARBOR, MI 48108 | 1.888.213.5015 | WWW.LEONSPEAKERS.COM
[Mounting into stud] Use two WOOD SCREWS with BONDED WASHERS to secure WALL PLATE
[Mounting into drywall] Use FLIP TOGGLE (instructions on the left) and then secure WALL PLATE using TRUSSHEAD SCREW with
BONDED WASHER in the center hole. Screw WOOD SCREW with BONDED WASHER into the outer pilot hole.
Fig. 3
1 2
3 4
5 6
Fig. 4
Remove the TEMPLATE and connect wiring to speaker. Mount speaker by sliding the SLOT RAILS (located on the back of the speaker)
over the WALL PLATES . Minor adjustments can be made by sliding the speaker horizontally or shifting the WALL PLATES vertically.
SLOT RAIL
Draw a guide line for where the top of the speaker should be
located. Secure the TEMPLATE 1.5” below the guide line using
painter’s tape (not provided).
Fig. 1
Put WALL PLATES in the TEMPLATE , then mark pilot hole locations
in the center and outer holes on each wall plate. Remove WALL
PLATES and then drill pilot holes using drill bits sizes shown above.
Fig. 2
1.5”
FLIP TOGGLE
WOOD SCREW
WOOD SCREW
WOOD SCREW
3/32” drill bit for WOOD SCREW
1/2” drill bit for FLIP TOGGLES
Mounting into drywall:Mounting into stud: