Levitas Design STRATO User manual

Measurements and Guide For Installing
STRATO - Illuminated Glass Bedside Table
12mm
Maximum Screw Diameter
6mm
Maximum Screw Width
120 mm
360mm
134mm
120 mm
45mm 45mm
15.5mm
Dotted line represents the area required for additional support
to securely attach the bedside table if attached to plasterboard.
We recommend that the centre of
the Bedside Table is approximately
in line with the top of your mattress.
20mm hole required
to feed the LED strip into
the channel.
Screw Locations

1. Use wire to attach the LED strip to
pull through the plasterboard.
2. Follow diagram on rear side. Mark 3
dots in a straight line (approx height
of mattress) 12cm apart & attach
screws.
3. Gently pull wire & bring the LED
strip through the wall - switch on in
advance to ensure LEDs are working
(NOTE: LED strips are fragile - do not
use excessive force)
4. Feed the LED strip into the
aluminium channel until central.
5. Place the STRATO on the three screws
in the wall - then slide to the right and
Avoid pinching/damaging LEDs.
6. Once the STRATO is level, place a
long screwdriver into the slot and
tighten the screws securely.
7. Ensure glass is rmly inserted into
the housing in front of the LEDs. Wear
hand protection if force is required to
push it into place.
8. Remove adhesive (cover) and
attach end cap.
NOTE: Centre of the two 20mm LED holes are 2020mm apart (Super King Bed)
How to install STRATO Illuminated Glass Bedside Table
Apple Android
Get the light
customisation app here: