LG LDF9810ST - Fully Integrated 6 Wash Cycles... Setup guide

1
LDF9810ST – Steam Dishwasher
Product Training
STEAM
DISHWASHER
LDF9810ST
Ver. 1.0 080123

2
LDF9810ST – Steam Dishwasher
LG Electronics in no way supports, condones, or will
tolerate the solicitation of personnel while in attendance
to this, or any LG event. Furthermore, there will be no
communication of salary, benefits or job descriptions in
general. Anyone found to be part of any such
communication will immediately be dismissed from this
class, and will not be allowed to attend future events.
LG supplies this training class for the benefit of all in attendance, we ask your
assistance in keeping this a professional meeting and to remain focused only on the
technical improvement and education of our service network.
No Solicitation

3
LDF9810ST – Steam Dishwasher
Safety Notices and Warnings 1
Contact Information 1
Contents 2
Specifications 4
Safety Notices (Gas and Electric) 5
Serial Number Identification 6
Introduction 7
Controls 8
Installation 9
Accessories 10
Drying Rack 10
Contents
T-1

4
LDF9810ST – Steam Dishwasher
IMPORTANT SAFETY NOTICE
DISCLAIMER
MODIFICATIONS
ESD ISSUE
REGULATORY INFORMATION
Preliminary
T-3
Slide Number Page in Training Manual

5
LDF9810ST – Steam Dishwasher
COMPLIANCE
The responsible party for this device’s compliance is:
LG Electronics Alabama, Inc.
PO Box 240007
Huntsville, AL, 35813
Preliminary
T-3

6
LDF9810ST – Steam Dishwasher
Safety Tips
T-4
• Unplug or disconnect the dishwasher before
starting repairs.
• Steam is HOT! Use caution when dealing with live
steam or hot parts.
•Do not stand on the open door.
•Do not allow children to play in the dishwasher.
• Do see the rest of the safety tips on page 4 in the
training manual.

7
LDF9810ST – Steam Dishwasher
Warranty
T-5

8
LDF9810ST – Steam Dishwasher
Specifications
T-6
ITEM SPECIFICATION
Rated Input 120 VAC
, 60Ø
Installation Built-in
Capacity 14 place settings
Dimensions (inches) 23⅞ X 25 X 33⅞
Weight (pounds) 128
Door Color Black, White, Stainless
Tub Stainless Steel
Control Electronic
Programs 6 Cycles

9
LDF9810ST – Steam Dishwasher
Features
T-6
Ultra Large Capacity
Removable Cutlery Rack
Slim Direct-Drive Motor
Hybrid Drying System
Vario Spray System
Self-Cleaning Filter
Dual Intensity™ Wash Cycle
Steam Washing and Steam Delicate™
Light Tough Buttons and Blue LCD
Auto-Off

10
LDF9810ST – Steam Dishwasher
Features
T-7
1. Control Panel
2. Door Handle
3. Front Cover
4. Lower Cover
5. Leveling Foot
6. Side Cabinet
7. Base

11
LDF9810ST – Steam Dishwasher
Features
T-7
8. Top Spray Arm
9. Upper Spray Arm
10. Removable Tines
11. Steam Nozzle
12. Lower Spray Arm
13. Dispenser
(Detergent / Rinse Aid)
14. Vapor Vent Cover
15. Tub Lamps
(IllumiTub™)
16. Cutlery Rack
17. Upper Rack
18. Cutlery Basket
19. Lower Rack
20. Blue LCD Display
21. Power Button

12
LDF9810ST – Steam Dishwasher
Installation
T-8
Installation is covered briefly for the servicer who may
need to uninstall and reinstall the dishwasher for repairs.
For new installations, please refer to the installation guide
that was supplied with the dishwasher.

13
LDF9810ST – Steam Dishwasher
Installation
T-8
Drill a 1½” hole on either
side to allow for the drain
hose, water supply hose,
and electrical cable. The
opening must be in an area
within 4” (100 mm) of the
back wall and 4” (100 mm)
of the floor.
If there is a floor in the
cabinet under the sink, it
will be necessary to cut
through it to connect the
water, drain, and electrical
cable under the sink.

14
LDF9810ST – Steam Dishwasher
Installation
T-8
The dishwasher must be
supplied with 120 VAC 60 Hz
1Ø current as indicated on the
rating plate and connected to a
properly fused and grounded
dedicated 20-amp circuit.
The wire or water supply can
be fed from either side, and
both from the same side,
depending upon source
location.
They must be run in the
channels under the dishwasher,
as shown in the drawing.

15
LDF9810ST – Steam Dishwasher
Electrical Installation
T-9
The dishwasher can be hardwired if necessary and if
permitted by local code. We recommend the use of a
dishwasher installation kit, available at most hardware and
home supply stored. This kit includes a cordset, a flexible
water supply line, and the elbow connector necessary to
connect it.
Using a cordset requires an electric outlet under the sink
accessible when the dishwasher is installed. The cordset
makes it easier to disconnect the dishwasher from power
while working on it and makes removal and replacement
easier. As stated earlier, installation requires a properly fused
and grounded dedicated circuit.

16
LDF9810ST – Steam Dishwasher
Water Supply Preparation
T-9
The dishwasher may be connected to either HOT or COLD
water. If the hot water can not maintained below 149° F, the
dishwasher must be connected to the cold water supply.
Lay out the water supply line as indicated on page 14 of the
training manual. Use sealing tape or joint compound to
avoid leaks.

17
LDF9810ST – Steam Dishwasher
Installation
T-9
Adjust the legs to the required height for the dishwasher
to slide under the countertop and be level. Check the
level using a spirit level.

18
LDF9810ST – Steam Dishwasher
Installation
T-9
Attach the leveling feet kit to allow for fine tuning when the
dishwasher is pushed into place.

19
LDF9810ST – Steam Dishwasher
Installation
T-9
To complete the installation:
Remove the lower cover.
Make sure the legs are adjusted
and the dishwasher is level.
Lay out the electrical cable,
water supply tube, and drain
hose as shown.
Slide the dishwasher carefully
back into place.
Make the appropriate
connections, as directed on
subsequent slides.

20
LDF9810ST – Steam Dishwasher
Drain Connection
T-10
The drain hose must be connected in a manner that
meets the local plumbing code. If the end of the drain
hose does not fit the available connector, an adapter
may be obtained from a local hardware or plumbing
supplier.