1. Affix the mounting template(supplied) to the mounting surface. 2. Secure the camera mounting base to the position where the camera
should be mounted with the supplied tapping screws.
(Please leave a good position of cable not to interrupt the survelliance
area with it when installing.)
3. Adjust desired scene by turning and moving the direction of he ball
mount camera and cover the top-cover.
4. Then you can fix it to screw-down the hexagonal bolt with the supplied
“L” wrench.
POWER
INPUT-
DC12V
VIDEO
OUTPUT
ROTATING PANNING TILTING
2. Lens Focus Adjustment1. Having a better view , adjust the camera
* The Lens is focused far from 1M when ex-factory.
Therefore we recommend the lens focus as is.
WARNINGS & CAUTIONSWARNINGS & CAUTIONS
The information is provided to ensure your safety and to prevent any losses, financial or otherwise. Please read it
carefully and use the product accordingly.
* For productinquires, please contact the retail shop where you bought the camera. The use of equipment such as
an aerial ladder while providing after-sales service shall be at your expense.
NOTES
* Please make sure the product is installed appropriate places where secured from flood,
such as under the eaves, to operate properly.
* This product is certified as IP66 standard. However, if there is any flood concerns, you shall
ask the service center if it would be OK to install where you want. P/N : COV00000000
video output
power input
Connect power jack in green to the power supply
and video jack in yellow to the monitor(or DVR if available)
CONNECTION & ADJUSTMENTCONNECTION & ADJUSTMENT
CONNECTION
Connecting power source
Connect a power source to the input terminal correctly. You can see
“+”, “_” on the plug of the cable. You can refer to connect a power source
to the power input terminal as shown below.
INSTALLATION
Installing the camera on a ceiling or wall
