LGHM SHOES BENCH User manual

SHOES BENCH USER MANUAL
Email:[email protected]

-1-
List of Hareware

-2-
List of Parts

-3-
Generally, A and C are applied at the same time, then use the B nut to tighten with A.
How Cam Lock System Works:
B
C
C
B
AC
BC
B
B

A
D
B
Ax4
Bx4
Dx4
-4-
STEP 1
Insert the screws A and LONGER sticks D on the left of No.8 board first,
then use the nuts B to tighten with A.

Ax4
Bx4
A
B
-5-
STEP 2
Insert the screws A on the right of No.8 board, then use the nuts B to tighten with A.

Ax4
Bx4
Cx4
A
B
C
-6-
STEP 3
Install No. 6 board. There are small 6 pre-drilled holes on the LEFT of No. 6 board for metal
stick K, make sure the RIGHT of No. 6 board insert screws and sticks( Important), and two
large pre-drilled hole are on the up side. Then align all the pre-drilled holes and put them
together gently. Finally use the nuts B to tighten with A.

Dx2
Ax4
Bx4
Cx2
AC
B
-7-
D
STEP 4
Install No. 7 board. Please insert TWO LONGER sticks D and screws on the top of
No. 7 board , insert sticks C and screws on the bottom of No. 7 board. Then align all
the pre-drilled holes and put them together gently. Finally use the B nut to tighten with A.

A
Ax2
Bx2
B
-8-
Small hole
STEP 5
Install No.9 board. There is a small pre-drilled hole on NO.9 board to install the door,
make sure the small hole on the front.

Ax2
Bx2
Cx2
A
B
C
-9-
STEP 6
Install No.4 board.

C
x8
Cx8
-10-
STEP 7
Note: There is small pre-drilled hole on the RIGHT of No.2 board to install the door,
make sure the small hole on the right.
Insert the sticks on No.2 board first, then tighten it with the screws I.
Small hole

x2
Cx2
C
-11-
STEP 8
Install No.3 board. Insert the sticks on No.2 board first, then tighten it with the screws I.
Note: Make sure two large pre-drilled hole are on the up side of the No.3 board.

A
A
A
B
Ax10
Bx10
Cx10
C
C
B
-12-
STEP 9
Install No.1 board. Please insert sticks and screws on the No. 1 board first, then align all
the pre-drilled holes and put them together gently. Finally use the B nut to tighten with A.

Kx4
K
-13-
STEP 10
Please insert four metal sticks K on the No. 3 and No. 6 board, then place the board
No.10 on them.

Hx2
x1
Ex2
H
E
-14-
STEP 11
Note: G1 and G2 are packed together. Need to be separated when applying.
Install G2 on No.12 board first.

x1
Ex2
E
-15-
STEP 12
Install G2 on No.7 board.

-16-
STEP 13
Insert H on No. 12 board up and down each.

-17-
STEP 14
Apply hook and loop.