Liberty Flights XO Tank User manual
FeaturesStructureIntroduction
• Stainless Steel and Pyrex Construction
• 510 Connection
• Child Lock Top and Bottom
• Easy Top Fill
• Compatible with;
- XO 0.5Ohm SS Coil (Stainless Steel)
(Direct Lung)
- XO 1.8Ohm Kanthal Coil
(Mouth-to-Lung)
- XO 0.2 Ni200 Coil
(Temperature Control)
Child-Lock
Exchange the Coil HeadHow to Top Fill
User manual
Cleaning &Maintaining
When necessary clean the components (except the coil head) by
washing with clean water and air drying the components.
The glass tank should not be impacted, dropped, or mishandled.
Doing so could damage the glass tube and injury may occur.
This product is not intended for use by any one under the age
of 18. Do not operate or heat the coil outside of its designed
container. Doing so may cause serious injury as the coil can reach
high temperatures. Seek medical advice if you feel unwell or are
pregnant. Not recommended for young people or non-smokers.
There are no recorded medical side effects for this product.
Bypass mode should only be used by advanced users with a good
understanding of Ohm’s law and battery cell safety. Failure to do
this may result in thermal runaway or serious injury. All usual time
and voltage protections still apply.
Liberty Flights is not liable for any malfunction of any mods or
battery, injury or death related to use of separate batteries and
mods made by other manufacturers. Do not operate in the rain.
Do not expose it to water when attached to a battery device.
Warning
Drip Tip
BottomCap
Pyrex Glass Tube
Top Cap (Child-Lock)
Airflow Control
Coil Head
46mm
23mm
12mm
TA NKTA NK
User Manual
The XO Tank is leak free, has child locking
safety features and the dual lines design
keeps the tank cool and the vapour
production plentiful.
Contents;
1 x XO Tank (2ml)
2 x Coils (See each coil
for resistance)
1 x Replacement Glass
1 x Set Replacement O-Rings
The XO Tank features innovative
child-lock technology sealing the tank
from the top and bottom when full.
To release the top and bottom cap, firstly
press down and unscrew the top cap and
remove, once removed grasp the internal
section and unscrew the bottom cap.
Once the bottom cap is removed the
outer glass tube can slide down and
be replaced.
To learn more about our products and vaping contact:
XO atomizer heads and accessories are
designed and manufactured with a high
consumer focus. Utilising advanced
methods of manufacturing and material
selection, these XO atomizer heads
deliver a consistent vape every time.
CAUTION
1. These coils utilise organic cotton wick,
please do not activate without the presence
of e-liquid.
2. It is recommended to saturate the coil prior
to vaping, please allow 3 minutes for coil to
saturate before firing.
COILSCOILS
To fill your XO Tank, firstly
push down and screw off the
child lock top cap and place to
one side. Once removed place
the nozzle of your e-liquid
bottle directly into one of the
two filling ports in the top of
the device. Be careful not to
insert the nozzle into the
centre shaft.
Fill the tank with
e-liquid to the top.
Use the glass as an
indicator. Ensure
the unused fill port is
free from obstruction
as this releases air
during filling.
1. Screw off the child-lock top cap
2. Hold internal section and screw off base
3. Screw out and discard old coil head
4. Prime coil head with 2-3 drops of e-liquid
5. Screw in new, primed coil head
6. Re-attach tank section to base
7. Fill tank via top filling port, attach top cap and enjoy
1. 2. 3.
4.5.
6.
Hold
Hold
Hold
Hold
Twist off base
Press down
& Twist
√ X √ 2.6mm
nib
3.0mm
holes
TANK
Once full please allow
3 minutes before vaping..
www.liberty-flights.co.uk
8-9 Arkwright Court, Darwen,
Lancashire, BB3 0FG
Tel. 0345 257 9008
XO Coils
The XO Tank comes with 2 atomizer heads please find
below the various heads that fit the XO Tank.
0.5Ohm SS (Stainless Steel) - Perfect for temperature
control (SS Mode) vaping or higher wattages and direct
lung inhales.
1.8Ohm Kanthal - Tighter airflow draw through the coil.
Perfect for mouth to lung inhales. (Not temperature
mode compatible)
0.2Ohm Ni200 - Perfect for temperature control (Ni
Mode) vaping and direct lung inhales. (Please note these
coils only work in XO Dynamic and XO Cloudchaser kits
and other temperature control devices)
0.2ΩNI200
(Temperature Control
0.5ΩSS
(Direct Lung inhale)
1.8ΩKanthal
(Mouth-to-Lung inhale)
(
*Advanced on. Bass
Mode M
zz
c_
r
Tempeture Mode
X
=§
"�0=
and
Bae:
Ml# �-
or
This manual suits for next models
1
Other Liberty Flights Vaporizer manuals
