Liberty Furniture 227-C9201S User manual

Thank you for purchasing this quality product. Be sure to check all packing material carefully for
small parts, which may have come loose inside the carton during shipment. Identify and count all
parts and compare with the parts list below.
LIBERTY FURNITURE
ASSEMBLY INSTRUCTION
NO DESCRIPTION QTY
PARTS LIST
DRAWING
MADE IN VIETNAM Page 1/2
Seat
STEP 1
NO DESCRIPTION
QTY DRAWING
HARDWARE LIST
B
3
6
4
5
AChair Back
Front Leg
C
DSide Stretcher
1
1
2
2
5
14
6
A
D
D
C
C
STEP 2
STEP 3
STEP 4
Do not fully tighten Bolts
until the assembly is completed.
7
DESCRIPTION: LATTICE BACK SIDE CHAIR
ITEM# :227-C9201S
Bolt Ø5/16"x75mm
Bolt Ø5/16"x50mm
Spring Washer Ø5/16"xØ13mm
Flat Washer Ø5/16"xØ19mm
Allen Key 4mm
Bolt Ø5/16"x38mm
Wood Screw
4
4
2
10
10
1
4
1
2
3
4
5
6
7
A
B

Chair Assembly Tips
ISSUE: CHAIR IS UNLEVELED
Cause:
. Chairs can be wobbly or unleveled if one or more bolts are fully tightened before all
bolts are attached and/or tightened.
Solution:
. Loosen each bolt in the seat box ( front
legs, back corner- blocks, and back apron)
until they're finger tight. Place the chair
upright on the floor. Press firmly and
evenly on the seat edges until the product
sits level but do not lean against the chair
back. Once the chair sits level on the
desired surface, fully tighten each bolt.
Cause:
.Chair can be wobbly or unlevled if
assembly is completed in a different room
or surface than where the product is
ntended to primarily reside.
Solution:
When assembling your chair, make sure to do it in the location that the chair will
most often be used. Uneven flooring frequently accounts for wobbling issues.
ISSUE: HOLES ARE MISALIGNED
Cause:
.This issue can occur when some bolts are tightened fully before all othe bolts
are tightened or attached.
Solution:
.Loosen each bolt in the seat box (front legs, back corner-blocks, and back apron)
until finger tight. This will allow you to realign the holes and properly fasten
the bolts to the frame.
MADE IN VIETNAM
Having some trouble putting together your new furniture? we can help! The key to correct chair
assembly is to loosely attach all of the bolts, then gradually tighten them in succession until all of
them are secure. Completely tightening one or more bolts prematurely can result in the
following:
Loosen Bolts unit
adjustable by hand
Page 2/2