LifeShield RC8221 User manual

The RC8221 is an indoor camera with built-in Infrared LEDs for night vision. To use:
Camera Model RC8221
Plug camera into power and Ethernet, wait
for power and network LED
1
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
*Wireless, or WiFi, technology allows an electronic device to exchange data wirelessly (using radio waves) over a computer network.
Once all cameras are found,
press OK
3
Use LifeView to edit settings,
including name and WiFi*
4
2On Console select
Menu Cameras Add New

Notes
To reset, insert paperclip
into reset button for at least
5 seconds, and release
Must be on same router as your
LifeShield Base to setup. After
setup, plug into power where
you like
Setup WiFi using Camera
Settings in LifeView, then
disconnect Ethernet cable,
remove and reconnect power.
Setup Alerts in LifeView to take
pictures when sensors trigger
Live video limit per session is
5 minutes
POWER
WPS
PRIVACY
RESET
POWER
NETWORK
Do not use the
WPS button,
microSD slot,
or green wire
connector
For support call: 877-464-7437 or visit: www.lifeshield.com/support