LifeSpan Kids LK 51 JUNIOR JUNGLE User manual

LK 51 JUNIOR JUNGLE - SWING SET FRAME
OWNER’S MANUAL
The disassembled product contains small parts which pose a chocking hazard to children under 3.
The owner’s manual contains safety, assembly , use and maintenance instructions. The product must be assembled by an adult who has read and understood these
instructions. Keep the packaging away from children and dispose of all packing before use.
For the installer and your children’s safety ,It is important to fully read and understand the instructions and safety hazards before commencing the assembly of the product.

GENERAL SAFETY INSTRUCTIONS
PURPOSE
This product is intended for outdoor, domestic use only. It is not suitable for commercial or medical use.
1.1 DANGER FOR CHILDREN
WARNING! No eating while using the product
• This product may only be used with adult supervision at all times.
• The packaging material is not suitable for children due to choking and suffocation hazards.
• Not suitable for children under 3 years.
• Max Users: 2
• Max User Weight: 50kg
• Max Fall Height for this produce is 180cm.
• It should be used in combination with the corresponding components. It cannot be used as standalone.
1.2 RISK OF INJURIES
• Do not use the product if it is damaged or defective. If it is damaged or defective, please contact a qualified technician.
• Check the product before each use. Defective parts must be changed immediately as they can impair the function and the safety of the product.
• Use the product only on even and non-slipping surfaces. Never use it near water and keep enough space around for safety.
1.2 PRODUCT DAMAGE
• Do not make alterations to the product. Only use original spare parts. Qualified technicians should only carry out repairs – improper repairs can lead to
danger for the user. Use this product only as described in this manual.
1.3 ASSEMBLY ADVICE
• The product should be installed over impact absorbing surfaces such as sand, wood-bar chips, rubber and foam and should not be installed over
concrete, asphalt or any hard surface.
• This product should be anchored into ground with concrete in 350(L) x 350(W) x 350(D)mm.
• The assembly of the product must be done carefully and by an able-bodied adult. If in any doubt, ask a technically qualified person.
• Before you start with the assembly, read the instructions carefully.
• Remove all packaging materials and lay down all parts on an open space. This gives you an overview and simplifies the assembly procedure.
• Check with the parts list that all parts are available. Dispose of the packaging material when the assembly is completed.
• Beware that when using tools or doing technical work, there is always a risk of injuries. Assemble the product with care.
• Create a danger free environment; for example, do not let tools lay around the workspace. Store the packaging material in a way that cannot cause
• any danger.
• After installing the product according to the instruction manual, ensure all screws, bolts and nuts are correctly installed and tightened and that all joints
• are secure.
• Reasonable space must be kept between the product and possible sources of danger, such as other equipment swimming pools and fences.
• The product must be assembled correctly before use.
• Place the product on a level surface at least 2 m from any structure or obstruction such as a fence, garage or house.

• No modifications are to be made to the original product.
• The product must always be used in a well-lit area.
• Use gloves during assembly and disassembly.
• Outdoor products should be equipped with a device that in strong wind conditions avoid displacement due to wind (e.g. steel bars in the ground or
• loads like sandbag or water bags).
• In certain areas during winter, snow build-up and the low temperatures can damage the product. It is recommended to remove snow build-up and to
• store the product indoor.
• We strongly recommend visual inspections every 3 months to ensure the integrity of the entire product. Replace any parts as necessary.
• Direct sunlight may cause the equipment to become hot. To prevent injury, we recommend storing this under shade.
SAFETY INSTRUCTIONS
• The safety instructions of the product should always be considered and obeyed.
• Using the product may result in permanent injury such as paralysis, or even death. Falling off the product may lead to injuries, particularly to the back,
neck or head.
• No clothes with hooks or lose parts should be worn or carried during product usage in order to avoid hooks getting caught and causing injury.
• Moving the product whilst assembled may affect the integrity of the frame. Should it be necessary to move the product, please consider the following:
1.) Force to be evenly spaced around the frame to lift the product off the ground
2.) The product must be carried horizontally
3.) Use caution whilst moving as it could bend the product frame.
• Users should be familiar with the assembly manual. This manual contains assembly guidance; selected precautionary measures as well as
• recommendations for servicing and maintenance of the product, in order to ensure safe and fun usage.
• It is the responsibility of the owner or the supervisor to guarantee that all users of the product are informed sufficiently of all warning references and
safety instructions.
For the supervisor:
The supervisor’s role is to make sure users are aware of all safety precautions and that these precautions are enforced. When a supervisor is not available,
the product may be disassembled or covered to limit access.
• The product can be only used if it is in good condition, worn or damaged parts should be replaced.
• Objects, which could be dangerous to the user, should be away from the product
• Avoid unauthorized and unsupervised use of the product.
• Do not use the product under influence of alcohol or drugs (incl. medicines).
• Do not use the product or its attachments as a jumping platform.

Consumer Information Sheet for Playground Surfacing Materials
The US Consumer Product Safety Commission (CPSC) estimates that about 100 000 playground equipment-related injuries resulting from falls to the ground
surface are treated annually in US hospital emergency rooms. Injuries involving this hazard pattern tend to be among the most serious of all playground injuries,
and have the potential to be fatal, particularly when the injury is to the head. The surface under and around playground equipment can be a major factor in
determining the injury-causing potential of a fall. It is self-evident that a fall on to a shock-absorbing surface is less likely to cause a serious injury than a fall onto
a hard surface. Playground equipment should never be placed on hard surfaces, such as concrete or asphalt, and while grass may appear to be acceptable, it
may quickly turn to hard-packed earth in areas of high traffic. Shredded bark mulch, wood chips, tine sand or the gravel are considered to be acceptable shock
absorbing surfaces when installed and maintained at a sufficient depth under and around playground equipment.
Table B.1 lists the maximum height from which a child would not be expected to sustain a life-threatening head injury in a fall on to four different loose-fill
surfacing materials if they are Installed and maintained at depths of 150 mm, 225 mm and 300 mm.
Table B.1: Fall height in millimetres from which a life-threatening head injury would not be expected
However, it should be recognised that all injuries due to falls cannot be prevented, no matter what surfacing material is used.
It is recommended that a shock absorbing material extend a minimum of 1 800 mm in all directions from the perimeter of stationary equipment such as climbing
frames and slides.
This information is intended to assist in comparing the relative shock-absorbing properties of various materials. No particular material is recommended over
another. However, each material is only effective when properly maintained. Materials should be checked periodically and replenished to maintain correct depth
as determined necessary for the equipment in question. The choice of a material depends on the type and height of the playground equipment, the availability
of the material in a particular area, and its cost.
Type of Material Depth of surfacing material
150mm
225mm
300mm
Double Shredded Bark
Mulch
1800
3000
3300
Wood Chips
1800
2100
3600
Fine Sand
1500
1500
2700
Fine Gravel
1800
2100
3000

M8X50MM a
M8X42MM c
8
7
Anchor e3
LK 51 JUNIOR JUNGLE - SWING SET FRAME
Parts List
Pictures Reference Par t# Qty
FC 5102 1
FC 5103 2
FC 4908 2
FC 4910 1
BR 01 8
BR 02 4
BR 03 3
FC 5101 1
U Bolts f6
FC 4909 1

ATTENTION:
1.DON’T fasten bolts until fully assembled.
2.DON’T over fasten bolts.
3.Before use, please check all bolts and fasten properly.
Combination A Step 1:
FC 5102
FC 5101
FC 5103
Step 1:
a
a
Step 2:
c
c

Combination A Step 2:
ATTENTION:
1.DON’T fasten bolts until fully assembled.
2.DON’T over fasten bolts.
3.Before use, please check all bolts and fasten properly.
FC 5102
FC 4908
FC 4909
FC 4910
FC 4908
a
a
a
a
aa
a
a
c
c
c

ex3
Combination A Step 3:

Combination B Step 1:
ATTENTION:
1.DON’T fasten bolts until fully assembled.
2.DON’T over fasten bolts.
3.Before use, please check all bolts and fasten properly.
FC 5102
FC 5101
FC 5103
Step 2:
c
c
Step 1:
a
a

Combination B Step 2:
ATTENTION:
1.DON’T fasten bolts until fully assembled.
2.DON’T over fasten bolts.
3.Before use, please check all bolts and fasten properly.
FC 4908
FC 4909
FC 4910
FC 4908
a
a
a
a
aa
a
a
c
c
c