Lightforce ROK40 User manual

ROK40 UTILITY LIGHTS
User Instructions
180724-2-ROK40-Instructions

The ROK40 comes with a full wiring harness
incorporating a 40 amp relay, a fully terminated two
pin waterproof Deutsch connector and an illuminated
switch. The in-line fuse is rated at 5 amps.
INSTALLATION INSTRUCTIONS
1. Mount the light in a suitable position
2. Fit the harness relay in a location near the
battery, where it will not be exposed to moisture
3. Fit the switch in a location where it will not be
exposed to moisture
4. Reattach the blue, red and black wires to the
switch as shown in Figure 2
5. Run the cable terminated with the female
Deutsch plug to the light and plug it into the
female plug
6. Connect the red ring connector to the positive
battery terminal and the black ring connector to
the negative battery terminal
7. Ensure all cables are secured
8. Test that the switch operates the light.
Figure 1
Relay
Switch
Deutsch
plug
Fuse
Black wire
Red wire
Blue Red Black
SWITCH WIRING
Blue: Switched power out
(12V DC)
Red: Power in (12V DC)
Black: Negative (required
for switch LED illumination.
Figure 2