Lepro 340017-DW-US User manual

User Guide
LED Flood Light
Max Torque N·m
d
Ø
100 W 175 mm / 6.9 in
150 W 175 mm / 6.9 in
200 W 200 mm / 7.9in
100 W 30
150 W 30
200 W 40
Accessories Not Included
Accessoires Non Inclus
Accesorios No Incluidos
12
3-1
3-2 3-3

≥ 15 m /
590.5 in
1 m / 39.3 in
Junction Box Not Included
Boîte de Jonction Non Incluse
Caja de Conexiones No Incluida
3*18 AWG
4 5
≥ 0.1 m / 3.9 in ≥ 0.1 m / 3.9 in ≥ 0.1 m / 3.9 in
a
b
c
100 W
150 W
200 W
269.5 mm / 10.6in 230 mm / 9.0 in 42 mm / 1.6 in
339.5 mm / 13.3in 291.7 mm / 11.5in 42 mm / 1.6 in
404 mm / 15.9in 331 mm / 13.0in 43.5 mm / 1.7 in
abc
1300g
1800g
3100g
g
15000 lm
Model NO. / Modèle No. / N°de Modelo:
10000 lm
20000 lm
100 W, 110-130 Vac, 50/60 Hz, IP65, 5000K, 0.85 A, PF>0.9, 110°, CRI≥80, -20 °C ~ 40 °C / -4 °F ~ 104 °F
150 W, 110-130 Vac, 50/60 Hz, IP65, 5000K, 1.27 A, PF>0.9, 110°, CRI≥80, -20 °C ~ 40 °C / -4 °F ~ 104 °F
200 W, 110-130 Vac, 50/60 Hz, IP65, 5000K, 1.68 A, PF>0.9, 110°, CRI≥80, -20 °C ~ 40 °C / -4 °F ~ 104 °F
340017-DW-US
340018-DW-US
340019-DW-US

1. This product is class I and must be earthed.
2. Please switch off mains supply before installation.
3. Ensure all seals are intact and operational after installation or maintenance.
4. Do not touch the light while in use or just after use to avoid being burnt.
5. Glass cover can break into small pieces.
6. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole
luminaire shall be replaced.
7. The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire
shall be destroyed.
8. SUITABLE FOR WET LOCATIONS
9. SUITABLE FOR OPERATION IN AMBIENT NOT EXCEEDING 40°C
THIS PRODUCT MUST BE INSTALLED IN
ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION
OF THE PRODUCT AND THE HAZARDS
INVOLVED
EN
1. Ce produit est de classe I et doit être mis à la terre.
2. Veuillez couper l'alimentation du secteur avant l'installation.
3. Il vous faut assurer que tous les joints sont intacts et opérationnels après l'installation ou la maintenance.
4. Ne touchez pas la lumière pendant l'utilisation ou juste après pour éviter de vous brûler.
5. Le couvercle en verre se brise en petits morceaux.
6. La source lumineuse de ce luminaire n'est pas remplaçable; lorsque la source lumineuse arrive en fin de vie,
l'ensemble du luminaire doit être remplacé.
7. le câble ou cordon flexible externe de ce luminaire ne peut être remplacé ; si le cordon venait à être
endommagé, le luminaire devrait être détruit.
8. CONVIENT AUX EMPLACEMENTS MOUILLÉS
9. PEUT ÊTRE UTILISÉ À UNE TEMPÉRATURE AMBIANTE N’EXCÉDANT PAS 40°C
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE
CODE D’INSTALLATION PERTINENT, PAR UNE
PERSONNE QUI CONNAÎT BIEN LE PRODUIT
ET SON FONCTIONNEMENT AINSI QUE LES
RISQUES INHÉRENTS
FR

5023480
Conforms to UL Std. 1598
Certified to CSA Std. C22.2#250.0
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
LEPRO INNOVATION INC
3651 Lindell Road Suite D1048, Las Vegas, NV 89103, USA
www.lepro.com [phone] [email protected]
Le Ming Trading Inc.
801-6081 No. 3 Rd. Richmond, BC, V6Y 2B2, CA
www.lepro.ca [phone] [email protected] Made in China Fabriqué en Chine
1. Este producto es de clase I y debe estar conectado a tierra.
2. Por favor, apague la fuente de alimentación antes de la instalación.
3. Asegúrese de que todos los sellos estén intactos y operativos después de la instalación o el mantenimiento.
4. No toque la luz mientras esté en uso o justo después de usarla para evitar quemarse.
5. La cubierta de vidrio se rompe en pedazos pequeños.
6. La fuente de luz de esta luminaria no es reemplazable; Cuando la fuente de luz llegue al final de su vida útil, se
reemplazará toda la luminaria.
7. el cable flexible externo o la cuerda de esta luminaria no se pueden reemplazar; si el cable está dañado, la
luminaria se romperá.
8. ADECUADO PARA LUGARES HÚMEDOS.
9. ADECUADO PARA FUNCIONAMIENTO EN AMBIENTE NO SUPERIOR A 40°C.
ESTE PRODUCTO DEBE SER INSTALADO DE
ACUERDO CON EL CÓDIGO DE INSTALACIÓN
APLICABLE POR UNA PERSONA
FAMILIARIZADA CON LA CONSTRUCCIÓN Y
FUNCIONAMIENTO DEL PRODUCTO Y LOS
PELIGROS IMPLICADOS
ES