Lights.com LC004949 User manual

1
INSTALLATION INSTRUCTIONS
1
ASSEMBLE BASE
Attach the 4 support feet into the slots on the
side of the base.
IMPORTANT
Before using your Lamplust Carroll 4-ft. Flocked Decorated Pop-Up Tree,
make sure that you carefully read through these instruction sheets.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations that
may occur. It must be understood that common sense, caution, and care are
factors that cannot be built into any product. This approach must be used
by the person(s) caring for and operating the tree.
GENERAL INFORMATION
The tree is suited for indoor use only. DO NOT attempt to replace or repair
any damaged cable parts. After use, ensure the tree is clean and dry
before storage.
DO NOT DISPOSE IN FIRE. Please dispose at your local recycling facility.
STEP BY STEP INSTRUCTIONS
Before using your tree, remove packaging. When setting up your tree,
carefully position cables to avoid a tripping hazard. The Pop-Up Tree
comes pre-lit and pre-dressed with baubles and bow ornaments in two
individual sections, with the lower section in a collapsed construction.
NO. LC004949
WHAT WE PROVIDE
• Carroll 4-ft. Flocked Decorated Pop-Up Tree
- Winter White
• 150 Warm White LEDs
• 27" Tree Bottom Dia.
• 16 Silver Shiny Ball Ornaments
• 16 Pearl White Shiny Ball Ornaments
• 18 Silver Glitter Snowflake Ornaments
• 4 Plastic Support Feet
• 1 Plain Burlap Fabric Tree Skirt, 25"
• 1 Base & 3 Trunk Frame Tubes
• Plug-in Power Supply w/ 6-hour Timer

INSTALLATION INSTRUCTIONS
2
2
3
4
NO. LC004949
ASSEMBLE TRUNK FRAME TUBES
Locate the three connectable trunk frame tubes and join
these together making one main trunk frame.
INSTALL LOWER SECTION OF TREE
Carefully fit the lower section over the top of the trunk
frame - ensuring that the top of the frame fits over and
within the inner central rim of the tree. Carefully let the
actual tree drop towards the ground, around the inner
trunk frame.
INSTALL TOP SECTION OF TREE
Locate the top section of the tree and connect this to the
hole on the upper end of the lower section. Connect the
wire coming from the top section to the wire coming from
the lower section and ensure the gasket is secured tightly
in place.

INSTALLATION INSTRUCTIONS
3
NO. LC004949
WARNING
This pre-lit tree is for INDOOR use ONLY. The tree stand must be placed on a flat rigid surface.
• Do not operate this product whilst in packaging.
• Disconnect from the mains supply when not in use.
• Do not operate in a confined space or allow to come into contact with any flammable materials.
• Do not allow any part of this set to come into contact with direct heat or flame.
• The transformer is a sealed unit, do not attempt to open or tamper with it.
• There are no user replaceable parts to this product.
• Please keep a free flow of air around the transformer.
6
ON/TIMER/OFF
Insert the plug into your wall outlet to illuminate the
tree. Press the button once to turn on the tree with no
timer. Press the button again to activate the 6-hour
timer. Once set, the tree will turn on and off at the
same time each day. Press the button a third time to
turn off the tree. NOTE: The LED lights are sealed units
and not user replaceable.
5
CONNECT POWER SOURCE TO TREE
Carefully move the tree to your preferred position
(ensuring that it is positioned on a rigid and level
surface). Connect the wire coming from the tree to the
transformer and ensure the gasket is secured tightly in
place.
Transformer
ON/TIMER/OFF
Control box