Lilly Rucky PUFFiT 2 User manual

Cleaning Wipe
Battery Module Heating Module
Housing
Mouthpiece Cap
USB Charge Cable
Do not operate the PUFFiT™2 if heating module is
not in the housing.
Do not clean the heating module or battery module
using water, or allow them to get wet.
Please charge your battery regularly!
When not using the PUFFiT™2 please disconnect
the battery module. Leaving the battery module
attached to the heating module for prolonged periods
of time can damage the battery and void your
warranty.
PUFFiT™2
PUFFiT™2
PUFFiT™2 battery module
PUFFiT™2
PUFFiT™2
PUFFiT™2
PUFFiT™2
Heat Shroud
Concentrates Insert
or
essential oils.
module
or open!
.
Packing Tool

Plug USB cable
into battery
charge port
Twist to lock
170 C / 320 F
185 C / 350 F
195 C / 375 F
220 C / 415 F
Charge until light
turns o
When using dry blends, fully load the heat chamber for best heating
Disconnect battery if you’re not using the PUFFiT™2
Use mouthpiece cap as an “oven mitt”when heat chamber is hot
Hold selection button down for 3 seconds to check battery level
TIPS AND TRICKS
Problem
No buzz when
battery held down
no LEDs lit up
LED 1 lit up
LED 2 lit up
LED 3 lit up
LED 4 lit up
Charge battery
Allow unit to cool for
30 minutes
If problem persists please
contact customer service
Please contact customer service
Low battery
Heat chamber too
hot
Internals too hot
Sensor error
Remedy
CAUTION:
This gets
really HOT!
Fill heat
chamber completely
for best heat transfer
CLEANING
TROUBLESHOOTING
Disconnect battery
and allow unit to cool
before cleaning
Clean the inside of
the heat chamber with
an alcohol wipe
or cotton tip
Use screen tool
to pop out screen
Replace by running
your nger around
the silicone ring
Use soap and water
to clean housing
Press down
on top and
hold until
you feel the
long buzz
1)
Heartbeat
buzzing
indicates
heating
2)
Cycle may be
repeated after
12 seconds
Two long buzzes
and it’s ready!
3)
8 Fast buzzes indicate a problem. Please check the LEDS :
( Leave disconnected
when not in use )
Press selection
button to set heat level
Apply concentrate
to sides of chamber
Push insert level with
chamber top
Remove screen from
base of heat chamber
For Concentrates
For Dry Herbs
Insert into
Housing
To stop heating press the top 3 or 4 times quickly
Do not use PUFFiT2 if
screen is not
correctly seated