Lincoln 1998 Lincoln Mark VIII User manual

Before driving
Introduction 2
Instrumentation 3
Controls and features 32
Seating and safety restraints 66
Starting and driving
Starting 88
Driving 93
Roadside emergencies 107
Servicing
Maintenance and care 123
Capacities and specifications 161
Reporting safety defects 167
Index 168
All rights reserved. Reproduction by any means, electronic or mechanical
including photocopying, recording or by any information storage and retrieval
system or translation in whole or part is not permitted without written
authorization from Ford Motor Company.
Copyright r1997 Ford Motor Company Elemental Chlorine Free
Contents
1

ICONS
Indicates a warning. Read the
following section on Warnings for a
full explanation.
Indicates vehicle information related
to recycling and other
environmental concerns will follow.
Correct vehicle usage and the
authorized disposal of waste
cleaning and lubrication materials
are significant steps towards
protecting the environment.
WARNINGS
Warnings provide information which may reduce the risk of personal
injury and prevent possible damage to others, your vehicle and its
equipment.
BREAKING-IN YOUR VEHICLE
There are no particular breaking-in rules for your vehicle. During the
first 1 600 km (1 000 miles) of driving, vary speeds frequently. This is
necessary to give the moving parts a chance to break in.
If possible, you should avoid full use of the brakes for the first 1 600 km
(1 000 miles).
INFORMATION ABOUT THIS GUIDE
The information found in this guide was in effect at the time of printing.
Ford may change the contents without notice and without incurring
obligation.
Introduction
2

P
5
0
1
2
34
6
7
RPMx1000
H
C
20
40
60 80
100
120
140
40
80 120
200
160
MPH
km/h
FUEL
FILL DOOR
F
E
BRAKE
888888.8
0
R
N
D
2
1
ABS
PREMIUM FUEL
RECOMMENDED
OFF
AUTO LAMP
DELAY
P
PANEL
DIM
INT
TIME
HI
LO
INT
OFF
MIST
ON
OFF
RES
SET
ACCEL
COAST
Headlamp control
(pg. 32)
Speed control
(pg. 43)
Driver side
air bag
(pg. 77)
Turn signal and
wiper/washer
control
(pg. 41)
Instrument
cluster
(pg. 6)
Ignition switch
(pg. 40)
Instrument panel
dimmer switch
(pg. 33)
Instrumentation
4

VEHICLE
SETTING DRIVER
SETTING
TRIP
ODO
RANGE RESET N
S
WE
FUEL
ECONOMY DATE
TIME
SYSTEM
CHECK
VOL-PUSH ON
AM
FM BASS TREB BAL FADE AUTO
SET
SEEK
TUNE
DISCS SCAN EJ TAPE CD
DOLBY 8 NR
REW
1FF
2SIDE 1-2
34COMP
5SHUFFLE
6
ST
FM 1
OUTSIDE TEMP
OFF
AUTOMATIC
MAX A/C VENT PNL•FLR FLOOR FLR•DEF DEF
HI
LO
OFF
LO HI
BOTH
BACK
HEATED SEAT
OFF
LO HI
BOTH
BACK
HEATED SEAT
PUSH PUSH
R.DEF.
Climate control
systems
(pg. 34)
Heated seat control
(if equipped)
(pg. 67)
Rear window
defroster control
(pg. 40)
Electronic sound system;
refer to Audio Guide
(pg. 39)
Message Center
(pg. 14)
Instrumentation
5

WARNING LIGHTS AND CHIMES
Anti-lock brake system (ABS)
Momentarily illuminates when the
ignition is turned to the ON position
and the engine is off. If the light
remains on, continues to flash or
fails to illuminate, have the system
serviced immediately.
Brake system warning
Momentarily illuminates when the
ignition is turned to the position ON
and the engine is off. Also
illuminates when the parking brake
is engaged. Illumination after
releasing the parking brake indicates
low brake fluid level.
P
5
0
1
2
34
6
7
RPMx1000
H
C
20
40
60 80
100
120
140
40
80 120
200
160
MPH
km/h
FUEL
FILL DOOR
F
E
BRAKE 000000.0
0
R
N
D
2
1
ABS CRUISE
ON
PREMIUM FUEL
RECOMMENDED
ABS
!
BRAKE
Instrumentation
6

Engine oil pressure
Illuminates when the oil pressure
falls below the normal range. Stop
the vehicle as soon as safely
possible and switch off the engine
immediately. Check the oil level and
add oil if needed. Refer to Engine
oil in the Maintenance and Care
chapter.
This lamp also illuminates when the ignition is turned to ON and the
engine is off.
Charging system
Momentarily illuminates when the
ignition is turned to the ON position
and the engine is off. The light also
illuminates when the battery is not
charging properly, requiring
electrical system service.
Traction ControlYactive
This light momentarily illuminates
when the ignition is turned to ON. It
also illuminates when the Traction
Controlysystem begins applying
and releasing the brakes and
adjusting the engine characteristics
to limit a wheelspin condition. It will
be lit for a maximum of four
seconds or for the duration of the Traction Controlyevent.
For more information, refer to the Driving chapter.
Instrumentation
7

Speed control (if equipped)
This light comes on when either the
SET/ACCEL or RESUME controls
are pressed. It turns off when the
speed control OFF control is
pressed, the brake is applied or the
ignition is turned to the OFF
position.
High beams
Illuminates when the high beam
headlamps are turned on.
Redundant electronic gearshift indicator
These lights operate with the key in
the ON position only and display the
same gear selection as shown on the
gear selector indicator located on
the floor console next to the
gearshift lever.
Turn signal
Illuminates when the left or right
turn signal or the hazard lights are
turned on. If one or both of the
indicators stay on continuously or
flash faster, check for a burned-out
turn signal bulb. Refer to Exterior
bulbs in the Maintenance and care
chapter.
CRUISE
ON
P
R
N
D
2
1
Instrumentation
8

Message center warning lights
The following warning lights are displayed directly above the message
center controls.
Safety belt
Illuminates when the ignition is
turned on to remind you to fasten
your safety belts. For more
information, refer to the Seating
and safety restraints chapter.
Check engine
Your vehicle is equipped with a
computer that monitor’s the engine’s
emission control system. This
system is commonly known as the
On Board Diagnostics System (OBD
II). This OBD II system protects the
environment by ensuring that your
vehicle continues to meet
government emission standards. The OBD II system also assists the
service technician in properly servicing your vehicle.
The check engine indicator light illuminates when the ignition is first
turned to the ON position to check the bulb. If it comes on after the
VEHICLE
SETTING DRIVER
SETTING
TRIP
ODO
RANGE RESET N
S
WE
FUEL
ECONOMY DATE
TIME
SYSTEM
CHECK
CHECK
ENGINE O/D OFF ANTI THEFT T/C OFF
CHECK
ENGINE
Instrumentation
9

engine is started, one of the engine’s emission control systems may be
malfunctioning. The light may illuminate without a driveability concern
being noted. The vehicle will usually be drivable and will not require
towing.
What you should do if the check engine light illuminates
Light turns on solid:
This means that the OBD II system has detected a malfunction. Have
your vehicle serviced at your first opportunity.
Temporary malfunctions may also cause your check engine light to
illuminate. Examples follow:
•The vehicle has run out of fuel. (The engine may misfire or run
poorly.)
•Poor fuel quality or water in the fuel.
•The fuel cap may not have been securely tightened.
These temporary malfunctions can be corrected by filling the fuel tank
with good quality fuel and/or properly tightening the gas cap. After three
drive cycles without these or any other temporary malfunctions present,
the check engine light should turn off. No vehicle service is required.
Light is blinking:
Engine misfire is occurring which could damage your catalytic converter.
You should drive in a moderate fashion (avoid heavy acceleration and
deceleration) and have your vehicle serviced at the first available
opportunity.
Under engine misfire conditions, excessive exhaust temperatures
could damage the catalytic converter, the fuel system, interior
floor coverings or other vehicle components, possibly causing a fire.
Air bag readiness
Briefly illuminates when the ignition
is turned on. If the light fails to
illuminate, continues to flash or
remains on, have the system
serviced immediately.
Instrumentation
10

O/D off
This light momentarily illuminates
when the ignition is turned to ON. It
also illuminates when the
transmission control switch been
pushed. When the light is on, the
transmission does not shift into
overdrive. If the light does not come
on when the transmission control switch is depressed or if the light
flashes when you are driving, have your vehicle serviced.
Anti-theft system
This light indicates the anti-theft
alarm system is armed. Refer to the
Controls and features chapter.
Traction Control Y off light
This light tells you that the Traction
Controlysystem has been turned
off using the Vehicle Settings menu
in the Message Center. The Traction
Controlysystem defaults to “ON”
(light is not illuminated) whenever
the vehicle is shut off and restarted.
This light will also illuminate if there is a total Traction Controlysystem
shut down.
If this lamp continuously stays on, contact your dealer for service as
soon as safely possible.
Headlamps on warning chime
Sounds when the headlamps or parking lamps are on, the ignition is off
(and the key is not in the ignition) and either front door is opened.
Safety belt warning chime
Chimes to remind you to fasten your safety belts.
For information on the safety belt warning chime, refer to the Seating
and safety restraints chapter.
O/D
OFF
ANTI
THEFT
T/C
OFF
Instrumentation
11