List Industries Classic KD 2-Person Locker Installation guide

Classic KD 2-Person & Duplex Locker
ASSEMBLY INSTRUCTIONS
General Instructions
1. Check material received against the packing list. Check the number of packages received and then check the
contents of each package.
2. Check the material received for damage. If damage has occurred, secure a “damage notation” from the carrier
3. Identify each part as it is unpacked and put like parts together as close as possible to the working area where they are
to be assembled.
4. Be careful to use the correct hardware as specified in the assembly instructions.
CAUTION
In the interest of safety, all lockers must be securely anchored to the floor and/or wall. For safety, handle all components
carefully and wear work gloves when assembling lockers. Install all units plumb and tighten all hardware securely. Retain
instructions for future reference.
800-776-1342
[email protected]
www.ListIndustries.com

www.ListIndustries.com
SHEET DRAWING NO. PART NO.
DESCRIPTION
REV. SCALE DATE
DATE
DATE
APPROVED BY
DRAWN BY
CHECKED BY
FRACTIONAL
X/X. ± 1/64
INCHES
XX. ± .010
XXX. ± .005
OF
TOLERANCES
UNLESS OTHERWISE
SPECIFIED
ANGULAR
± 1/2°
UNLESS OTHERWISE
SPECIFIED ALL
DIMENSIONS ARE IN
INCHES. METRIC
DIMENSIONS WILL BE
WITHIN [XX]
401 Jim Moran Blvd., PO Box 9601 Tel [phone]
Deerfield Beach, FL 33442 Fax [phone]
1
SA0160
ASSEMBLY INTRUCTIONS
DUPLEX & 2 PERSON LOCKERS
9/29/2010 JIL
1
THIS DRAWING AND THE INFORMATION ON IT IS THE CONFIDENTIAL PROPERTY OF LIST INDUSTRIES INC., AND SHALL NOT BE COPIED OR DISCLOSED TO OTHERS WITHOUT WRITTEN PERMISSION. ONLY LIST INDUSTRIES INC. RESERVES THE RIGHT TO ALTER ANY DESIGN. ANY UNAUTHORIZED MODIFICATIONS RELEASES
LIST INDUSTRIES INC. FROM ALL LIABILITIES.
STD. TOP SHELF
HAT SHELF
2- PERSON SHELF
SIDE PANEL
REAR PANEL
USE #10-24 X 3/8"
SLOTLESS HEAD BOLTS
FINGER TIGHTEN UNTIL STEP 3
2.
SQUARE GROUP BY
THE TOP AND
TIGHTEN THE BOLTS
BEFORE STANDING UP
3.
2 PERSON BOTTOM SHELVES
HAVE FRONT CUT-OUTS
PARTITIONS ARE BOLTED
TO SHELVES AND REAR PANEL
THEN RETAINED AT THE FRONT
BY THE CENTER FRAME
STD. TOP & MID SHELVES
1A
2 PERSON SHELF
TOP AND MID
HAT SHELF
2 PERSON BOTTOM SHELF
2 PERSON SHELF
DUPLEX
PLAN VIEW
1.
DOOR
CENTER FRAME
SIDE PANELS FIT "INSIDE" DOOR FRAME, NEVER BETWEEN
SIDE PANEL
(REVERSIBLE)
REAR PANEL
PARTITION RETAINED
IN CENTER FRAME
IMPORTANT:
ALL LOCKERS SHOULD BE
SECURELY ANCHORED TO
WALL AND/OR FLOOR WITH
SUITABLE FASTENERS
*
GROUP A MAX. OF 5 UNITS
TOGETHER FOR 15"
LOCKERS
*
GROUP A MAX. OF 4 UNITS
TOGETHER FOR 18"
LOCKERS
2-PERSON