Listen technologies Listenpoint lpt-m1 User manual

Line Input:

3.5 mm jack

for MP3 player

or other audio

source.

LED: Green - M1 on

Green Blinking - Muted

Red - Low battery

Red Blinking - Charging

Amber - Programming

functions

Soft Button: Typically mutes the

aux inputs. See customization

guide for advanced

programming options.

Volume Up: Increases the

microphone volume,

if muted, button increases

aux input level.

Mute/Power Off: Push to mute.

Hold down for four (4) seconds

to turn off.

Volume Down: Decreases the

volume, if muted, button

decreases aux input level.

Place M1 facing

forward in charging/storage

station after each use.

Power On: To turn

M1 on, push any

button for one (1) second.

Mic Input:

3.5 mm jack

for optional

external

microphone.

ListenPoint®Microphone/Media Interface Quick Reference

For further details regarding advanced options for your ListenPoint products download the

ListenPoint Customization Guide at: www.listentech.com/support-tools-downloads or

please contact Listen at +1.801.233.8992 • 1.800.330.0891 North America

The user is cautioned that any

changes or modications not

expressly approved by the party

responsible for compliance could

void the user’s authority to

operate the equipment.

ListenPoint®Microphone/Media Interface Quick Reference

The ListenPoint system offers two options to use the LPT-M1 ListenPoint Microphone/Media Interface (M1) with the system -

Instant On™(default setting) and Auto-Registration.

Instant On™ - The M1 is set to a specic frequency/channel. The default factory setting is set to channel 1. If there are more than one M1s in the

same room, additional units must be set on another channel to avoid interference.

To change channel, follow these instructions:

1. Power down the M1 by pressing and holding the mute button (button C) until LED goes out.

2. Press and hold buttons A & C for three seconds.

3. After holding down these buttons for three seconds, the LED will illuminate RED. Upon releasing the buttons,

the LED will blink RED rapidly indicating you are in programming mode.

4. While the LED is blinking, press button B to change the M1 to channel 2 (in a four M1 system, buttons C & D will

program the unit to channels 3 & 4). To put the unit back on channel 1, press button A.

5. The M1 will then be active on the chosen channel and the GREEN LED will be illuminated.

NOTE: To determine which channel the M1 is programmed to, turn the unit off/on. When the unit is initializing, the LED will blink RED – once for channel 1, twice for

channel 2 etc. All units are shipped default on channel 1. If there are two or more M1s in the same room, be sure one has been programmed to another channel.