Button
Memory Settings
1. Press the FLAT button to reset the bed.
2. Adjust the bed to your preferred position.
3. Press and hold the TIMER/ALL OFF button. Release the button when you see the blue backlight flashing on the remote
control (in about 3 seconds).
4. Press the Memory A or Memory B button. The blue light will stop flashing to indicate that the setting has been
successfully programmed.
5. (Repeat the process for a second setting.)
6. To activate your setting, press the corresponding Memory button when you next use the bed.
Dual USB Charging Ports
Located on the right side of the bed, 2 convenient USB
ports let you charge your portable devices.
Emergency Reset
If you temporarily cannot reach the remote control, press the
red emergency reset button to return the backrest and legs
to their lowest positions.
Operation Button Operation
Press and hold to raise the backrest.
Let go when desired position is reached.
Press and hold to lower the backrest.
Let go when desired position is reached.
Press and hold to lower legs. Let go
when desired position is reached.
Press and hold to lower both the legs and backrest.
Let go when desired position is reached.
Click to achieve zero gravity position (Factory
settings: Backrest 16.5°, Legs 35.5°).
Press and hold to raise legs. Let go
when desired position is reached.
Press and hold to raise both the legs and backrest.
Let go when desired position is reached.
Click to flatten the bed.
Click to set a user-defined position. Click to set a user-defined position.
Successively increase the intensity of the
backrest and leg massage in stages.
Successively decrease the intensity of the
backrest and leg massage in stages.
Set massage time: 10 min., 20 min. and 30 min.
stages. Press 30 min. again to delete all settings. Set massage frequency.
Click to turn LED flashlight on top of the
remote on and o.
Click to turn under-bed LED lights on and o.
5
