LK Systems ICS-RF User manual

1
Plug in the receiver unit.
Press the L-key for at least three seconds until L-LED
lights up green.
Remove the plastic from the battery of the thermostat.
Connect the actuators to the bottom row of terminal
plugs marked . Note! Not in the row marked
.
Make sure that the radio link is connected to the receiver
unit.
Remove the back of the thermostat by pressing the lock-
ing with a screwdriver or similar.
Quick Guide - Programming wireless thermostat
EN.33.C.140.1401
Room Temperature Regulation | Quick Guide - Programming wireless thermostat

2
EN.33.C.140.1401
Room Temperature Regulation | Quick Guide - Programming wireless thermostat
Press Mode on the thermostat until the ”checkmark” is
shown in the display.
Check that the selected channels are shown in the
display. Conrm with Mode. The thermostat switches to
normal view.
Complete the programming by pressing the L-key where-
upon the L-LED goes out.
The thermostat shows RUR.
The receiver unit´s L-LED switches to yellow and selec-
table channels light up green. Select channel by pressing
desired channel key. The selected channel ashes green.
Repeat steps 5-10 for the other thermostats in the facility.
The programming of the thermostats is now completed. For a more detailed as-
sembly instruction, see supplied instructions or www.lksystems.se.