Lmppos LMP-L1 User manual

Barcode Scanner
Quick Reference Guide
Set Defaults
Installation
Refer to the below pictures, connect the scanner based on
different cables:
USB:USB cable RJ45 connect bottom of scanner, the other
side connect PC.
USB cable
P/S 2:P/S2 cable RJ45 connect bottom of scanner, the other
side to connect PC and P/S2 port keyboard
P/S2 cable
RS232 cable
RS232:RS232 cable RJ45 connect bottom of scanner ,the
other side to connect PC.Power connect RS232 cable power
plug.
Typically, after connect data cable and scan on,the scanner is
able to identify the data port type automatically. In extreme
cases,scanner port may need setting manually if the scanner
fails to identify it.
Automatic Identification (Default)
USB
（PS/2）
RS232
How to scan:
When the scanner is scanning,ensure the scan line
crosses every bar and space of the symbol.
Right Wrong
Note：Indicator light flashing and with “beep” sound
that mean scan successfully.
Common Settings
Information inquire
Product info
Scanner Serial No
Suffix Quick Setup
CR（default）
LF
CR+LF
None

Scanning mode
Manual mode:Scan barcode need manually press trigger.One
press for one barcode.
Continuous Scanning Mode:The scan engine is always
scanning and decoding.The scanner will scan the barcode
which gets into the scanning area automatically.
Auto scan mode 1:The scanner will automatically scan the
barcode which gets into the scanning area one time.
Auto scan mode 2: When barcode gets into the scanning
area,then scanner will automatically open continuous scanning
mode. There do not have barcode to scan for long time.The
scanner will automatically close the scanning.
Manual mode(Default)
Continuous Scanning Mode
Auto scan mode 1
Auto scan mode 2
Note: 1.Under Continuous Scanning Mode,only when the
barcode get out of the scanning area, the scanner can
scan the next barcode.
2.Under Auto scan mode,please do not have any
obstacles in the front of scan windows(better keep
20cm).Because the obstacle will affect scanner
automatically scan.
Volume of beeper
High(Default)
Middle
Low
Mute
Prefix
Transmit Prefix
Do not Transmit Prefix (Default)
Scan Prefix(0~16 Chars, 2Digits/Char; 00~FF; 00*）
Suffix
Suffix(Default)
Do Not Transmit Suffix
Scan Suffix (0~16chars, 2 Digits/Char; 00~FF; 0D*)
Parameter bar code
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Finish Setting