Lumenier DLUX OSD User manual

User Manual
DLUX OSD
v1.0

DLUX Overview
The DLUX is an OSD (On Screen Display) that is used to embed many different types of
telemetry data from the Flight Controller on to the transmitted video.
The DLUX utilizes MinimOSD to configure the settings and graphics display layout. To learn
more about MinimOSD and download the Configuration Tool please go to: www.mwosd.com
1

Full Pinout (Pins 1-7)
1. U1 TX (USART) - The DLUX communicates information and sends request to the RX on the
flight controller.
2. U1 RX (USART) - The telemetry information comes in from the TX on the flight controller.
3. 5 Volts out Power - This can be used as an option to power a flight controller.
4. Ground - This can be used as an option to ground a flight controller.
5. Ground - Use this to provide a ground connection to the camera.
6. Power Out for Camera - This is an adjustable power for the camera. Can be set to 5V, 12V,
or Raw power from the battery. See the Power Logic & Configuration section for details.
7. Video Signal In - The Video signal from the camera connects to here. This is where OSD
information is embedded into the video.
2

Full Pinout (Pins 8-14)
8. U3 TX (USART) - The DLUX can use this as an alternative way communicate information and
sends request to the RX on the flight controller or an alternate RX on another source like a
GPS.
9. U3 RX (USART) - An alternative connection to receive telemetry information from a TX on
flight controller or alternate RX on another source like a GPS.
10. Battery Power In - The DLUX will need to receive power from the battery. This can be
connected to a battery directly or to a PDB (Power distribution Board). Voltage in range 7.4V -
18.5V (2S - 5S Lipo)
11. Battery Ground In - The DLUX will need to receive a ground connection from the battery.
This can be connected to a battery directly or to a PDB (Power distribution Board).
12. Ground - Use this to provide a ground connection to the VTX (Video Transmitter).
13. Power Out for VTX - This is an adjustable power for the VTX (Video Transmitter). Can be
set to 5V, 12V, or Raw power from the battery. See the Power Logic & Configuration section for
details.
14. Video Signal Out for VTX - The video signal with the telemetry info embed as OSD (On
Screen Display) comes from here and connects to the VTX (Video Transmitter).
3

Power Logic & Configuration
The DLUX can be configured to provide multiple power configurations.
RAW or 12V - The option to send the Raw Battery power or the Regulated 12V power though
the 12V connections on the CAM and VTX Pins.
VTX & CAM - You can choose to provide 5V or 12V/ Raw power by soldering the center pad to
the 5 or 12 pad.
Power out when using a 4S Battery: 12V 1,000mA & 5V 700mA
4

Advanced Use of the RX / TX Connections
The DLUX can be configured to change the U3 RX / TX Pins to be U1 RX / TX.
5

Setup in CleanFlight
1. Port Settings - In this setup we are using UART1 (T1 & R1) on a Lux Flight Controller. Set the
UART RX / TX Pins that you have connect the DLUX U1 or U3 to MSP on at 115200.
6

Setup in CleanFlight (Continued)
2. Configuration Settings - Turn the Telemetry Output On. That is it!
7