LuminoLite Night Light User manual

LuminoLite Night Light Instruction Manual
The LuminoLite Night Light can be free-standing or wall mounted.
Your night light will come with batteries, adhesive tapes and hooks, screws and
screw anchors.
ow to Install/Replace Batteries
1. Turn the night light so you are
looking at the back of the unit
and carefully remove the battery
cover.
2. Insert the batteries with polarity
in the correct position. As
indicated inside the case.
3. Place the battery cover back.
ow to Turn on The Light
There is a switch on the side of the light
with three settings. OFF, AUTO and ON.
imply slide the switch to your desired
setting.
AUTO mode will activate the motion sensor
and the light will turn on for approximately
30 seconds when it detects motion before
automatically turning off again.
ON mode will turn the light on and will stay
on until turned off again.

Screw-Mount Instructions
1. Match a drill bit to diameter of screw anchor (1/4 in from opening).
2. Mark hole position(s) on the wall. Drilling a pilot hole is recommended.
3. Drill hole(s) slightly deeper than the anchor is long.
4. Insert the anchor(s) fully and drive the screw in showing enough head to hang the light
on.
Adhesive Tape and ook Instructions
Please note. Use adhesive hook on a smooth, dry and clean surface.
Do not use on wallpaper, textured, rough or damp surfaces. As these types of
surfaces will affect adhesive strength of the tape. We recommend using the screw-
mount option instead.
CAUTION - Adhesive may damage your wall upon removal. Use at own risk.
1. Firstly, ensure the surface you are mounting onto is smooth, dry and clean.
2. Remove the backing tape off one side and affix the adhesive onto the back of the hook.
3. Remove the remaining backing tape off the adhesive and mount the hook onto the wall.
4. Press firmly and wait up to 3 hours for best results. This will allow for the
adhesive to set for a strong hold.
5. Mount the Night light onto the hook and pull down gently until you feel or hear a click.
6. witch the light onto Auto-mode to activate the motion sensor.
Battery Caution:
1. Use only new alkaline AAA-Cell batteries with 1.5V rating for best results.
2. Do not mix old and new batteries or mix Alkaline, tandard (Carbon-Zinc) or
Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries.
3. Do not dispose of batteries in fire.
4. Batteries should be recycled or disposed of as per state and local guidelines.
5. Install batteries with polarity in correct position.
6. If battery has leaking fluids, do not touch fluids, wash hands immediately.
IMPORTANT
Avoid proximity to heat sources such as fires, radiators etc as this may cause damage.
If the night light does not work/turn off or malfunctions:
- Ensure that the batteries are inserted correctly.
- Replace with new batteries.
- Check the contacts and connections are clean.
- Try pressing the switch several times.
Contact [email protected] if you require assistance.
LuminoLite are not responsible for the consequences, whether direct, indirect or
accidental, or for any other type of damage arising or resulting from the use of its products.