Lush Banners TT-FO-02-BLIT User manual

Trade Show Tower Square (Backlit) 8ft
TOP VIEW

Tools, Components, & Connectors
TC-30-3W x8 COL-T2 x8
COL-03-BL-G x1
COL-01-T1 x6
Graphics
Included In Your Kit
LED-CORN-24W x6COL-01-T3 x4
COL-T5 x2
TC-30-X x1
TC-30-T x4
WC-30T x3 LED-LT-FXT-3WAY x2
COL-01-T4 x1 LED-LT-PWR-CORD X2 WIRE CONNECTION CLIP x3

Labeling Diagram

Lighting Diagram
WC-30T
LED-LT-PWR-CORD x2

Gather the components to build
Section 1 of the tower frame.
Use the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Methods 1
for more details.
Gather the components to build
Section 3 of the tower frame.
Use the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Methods 1
& 4 for more details.
Gather the components to build
Section 2 of the tower frame.
Use the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Method 2
for more details.
Lay the three sections flat on
floor. Combine them to complete
the tower frame assembly. Use
the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Method 3
for more details.
Step 1.
Step 3.
Step 2.
Step 4.
Kit Assembly
Step by Step

Step 5. Step 6.
Kit Assembly
Step by Step
Close the zippers and carefully
stand the tower upright.
Setup Complete
Gather the components to
connect lighting to the frame.
Connect the lighting components
to the frame. Use the Exploded
View and Lighting Diagram for
part labels. These components
simply hang from tube T4 at the
top of the frame and the power
cable runs down and out of the
bottom opening.
-See Light Diagram

Connection Method 1: COL-01-T1/ COL-01-T2/ TC-30-3W
First, Connect bottom tubes (COL-T1) and side tubes (COL-T2) toTC-30-3W. Repeat previous step
until all four sides of bottom are assembled. Use this method for the TOP & BOTTOM.
Connection Methods
Slide the COL-T3 into the TC-30-T until it snaps in place. Repeat this for all 4 middle sections. Follow
same process with connecting COL-T2 to TC-30-T.
Connection Method 3: COL-01-T2/ TC-30-T/ COL-01-T3
Connection Method 2: TC-30-X
First, connect spreader tubes (COL-T3) to TC-30-X. Second, once the X frame is assembled, connect
side tubes (COL-T6).
Snap button connections are simple and easy to use. First, locate the snap button on the connector
or swage tube. Second, locate the hole on the corresponding tube. Press the snap button with your
thumb and slide the tube and connector together so that the snap button snaps fully into the hole.
To disassemble, press the snap button and carefully pull them apart.
Connection Method 4: COL-01-T4/ COL-01-T5