OYPLA DIY 3660 User manual
User Manual
USER MANUAL Model No: 3660
Heavy Duty 500kg Racking
•This product is not a toy and should only be used for its designated purpose.
•Make sure that the racking platforms are secure before applying any weight to the
product.
•This product can be used both indoors and outdoors.
•Only use this product on stable, level and dry ground.
•Leaving the product outside exposed to weather, especially direct sun, rain and salt air,
will speed the weathering process. This can be slowed by removing the product from these
conditions, or covering it with a suitable cover.
•Do not carry out alterations or modifications to this product.
•Do not discard any of the packaging until you have checked that you have all the parts
and fittings required.
•When adjusting the height of the shelves, be sure that the shelving is securely held in
place after adjusting the height to avoid it falling due to weight.
•Never exceed the maximum load capacity of 100kg per shelf or it may result in product
failure or personal injury.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product.
•If the product is damaged or has any defects, please contact cservice@oypla.com
USER MANUAL Model No: 3660
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 3660
1. Take two corner support bars and place
plastic feet on the bottom of both. After this,
lay both corner support bars side to side and
slide an end adjustment bar into place. Make
sure the metal folds on the end adjustment
bar go underneath the metal holds on the
outside of the corner support bar.
2. Once the end has been finished, slide a side
adjustment bar into place on either side of the
created frame. Make sure the metal folds are
on the outside. Repeat this on the opposite
side. After both sides are secured into place,
repeat step one and then attach that to the
opposite end of the side adjustment bars.
Assembly Instructions
3. Place a wooden shelf onto the first of the
racking platforms. Slide a side adjustment bar
higher up either side of the frame and an end
adjustment bar to either end of the frame.
Once this is done, place a wooden shelf on top
to create the second layer of racking.
4. Push a corner extender into each of the exposed
corner support bar tops. Once done, slide a corner
support bar onto the outside of the corner extender.
Make sure this is held securely as this area will be
holding the weight of the racking above. Repeat this
with the remaining corner support bars.
5. Repeat the previous steps for constructing the
racking supports. Once you’ve built the centre
racking platform, continue building upwards.
Maintain a fair amount of space between each
racking platform, this will allow for better storage.
Once you have completed the 500kg racking, go over
all the secured metal folds to make sure that the
racking is secure.
USER MANUAL Model No: 3660
Please retain a copy of all instructions for future
consultation.
Table of contents
Other OYPLA DIY Rack & Stand manuals
