Lush Banners TT-FO-02-BLIT User manual

Trade Show Tower Sqaure 10ft
TOP VIEW

Tools, Components, & Connectors
TC-30-3W x8 COL-02-T1 x8
COL-02-G x1
COL-02-T2 x8 COL-02-T3 x4 COL-02-T6 x4
Graphics
Included In Your Kit
TC-30-X x1

Labeling Diagram
Section 1:

Labeling Diagram
Section 2:

Labeling Diagram
Section 2:

Gather the components to build
Section 1 of the tower frame.
Use the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Methods 2
for more details.
Gather the components to build
Section 3 of the tower frame.
Use the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Methods 2
for more details.
Gather the components to build
Section 2 of the tower frame.
Use the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Method 3
and 4 for more details.
Lay the three sections flat on
floor. Combine them to complete
the tower frame assembly. Use
the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Method 1
for more details.
Step 1.
Step 3.
Step 2.
Step 4.
Kit Assembly
Step by Step

Kit Assembly
Step by Step
Leave the tower frame flat on
floor. Undo the zipper pillow
case and pull it over the top of
the tower. Work the pillowcase
down to the bottom of the frame
carefully zip it up and then stand
the frame upright.
Setup complete
Step 5. Step 6.

Connection Method 1: SNAP BUTTONS
Snap button connections are simple and easy to use. First, locate the snap button on the connector
or swage tube. Second, locate the hole on the corresponding tube. Press the snap button with your
thumb and slide the tube and connector together so that the snap button snaps fully into the hole.
To disassemble, press the snap button and carefully pull them apart.
Connection Methods
Connection Method 2: TC-30-3W-R
Snap button connections are simple and easy to use. First, locate the snap button on the connector
or swage tube. Second, locate the hole on the corresponding tube. Press the snap button with your
thumb and slide the tube and connector together so that the snap button snaps fully into the hole.
To disassemble, press the snap button and carefully pull them apart.
Snap button connections are simple and easy to use. First, locate the snap button on the connector
or swage tube. Second, locate the hole on the corresponding tube. Press the snap button with your
thumb and slide the tube and connector together so that the snap button snaps fully into the hole.
To disassemble, press the snap button and carefully pull them apart.
Connection Method 3: COL-02-T3/COL-02-T6 Connection Method 4: TC-30-X
First, connect spreader tubes (COL-T3) to TC-30-X. Second, once the X frame is assembled, connect
side tubes (COL-T6).