Macrom RMW704KR User manual

USER MANUAL
RMW704KR
7-inch monitor kit + wireless rear view camera
KITKIT
WIRELESSWIRELESS

- 2 -
• Before completing the installation, temporarly connect the wiring and make sure it works
properly.
• Use only the parts included with the unit to ensure proper installation.
Using parts not included in the package may cause malfunctions.
• This product must be installed by an authorized reseller to qualify for warranty.
• Install the unit in a location that cannot harm the driver or passenger to
avoid collusion in the event of a sudden stop, such as an emergency stop.
• Avoid installing the unit in places subject to high temperatures, such as direct su
light, hot air, or where it would be subject to dust dirt or excessive vibration.
• Be sure to remove the front protective film after installing the unit.
Installation
Monitor installation
Choose the position of the monitor in the vehicle so that it does not block your view and complies
with local laws for safe driving.
1. Dashboard
2. Support 1
2
Camera installation
Choose the position of the camera on the vehicle and before drilling the holes in the frame
necessary for fixing the U-shaped support, make sure that there are no underlying impediments
such as pipes or electrical wiring.
Note:
Before drilling the holes in the dashboard necessary for fixing the U-shaped support, make sure
there are no obstacles such as ventilation pipes underneath or electrical wiring.

- 3 -
Connections
Wifi Antennas
1. Connect the Wifi antenna( A ), 2.4Ghz.
AA
Power Supply
1.
Connect the monitor and camera harness to your vehicle’s ignition service.
Note:
Permanent direct connection to battery positive could lead to discharge of the vehicle battery in
the long run.
2. Make sure there is a 10 Ampere protection fuse.
1
3
2
Connection via cigarette
lighter
Connection via ACC power
Connection via ACC power

- 4 -
Front panel
1. Power key (On/Off)
2. Key Previous
3. Key Next
4. Rear view camera channel selection key
5. Menu key
6. SEL / Record & Stop key
7. Wifi antennas
Product overview
Warning:
The images in this manual are indicative only and may differ from the actual product. Please refer to the actual device unit.
12 3 4 5 6
7

- 5 -
Important
Before proceeding with the use of the monitor it is necessary to pair a rear view camera using the
pairing function.
Rear view camera pairing
1. Using the key (CH) select the channel to which you
want to connect the camera.
2. Enter the menu and select PAIRING to pair.
Press the SEL key to confirm the procedure.
3.The monitor shows the pairing procedure via
“countdown” on the screen
4. At the end, the image of the previously paired
camera will be displayed.
NOTE:
If you need to pair more cameras, please repeat the above procedure again selecting the
corresponding channel.

- 6 -
Video Recording / Playback
Recording mode
Before proceeding with the recording it is necessary to format
the new SD card.
Select the Recording mode using the cursor < / > and confirm
the "Format" selection by pressingthe SEL key. Confirm again
to format the SD cards.
To make a recording, press the SEL key, a flashing red dot
appears on the screen.
To end the recording, press SRL again.
Insert an SD card
Using a Phillips screwdriver, open the SD card door on the back
of the monitor and insert the SD card.
It is recommended to use a class 10 high-speed TF card (minimum)
or higher. Maximum allowed capacity of 128Gb.
Note:
The recording of the video signal relates only to the image of the camera/s displayed on the screen. If you
want to make multiple recordings, you need to view multiple cameras on the screen at the same time so
that the monitor can simultaneously record multiple channels.
Circular Registration
If you want to overwrite the entries, you must activate the
"Circular logging" function.
Select the Recording mode using the cursor < / > and confirm
the selection "Circular recording" by pressing the SEL key and
confirm again to activate the function.
Note:
When the function is active,the symbol appears on
the screen which confirms the activation of the overwrite.
Video playback
If you want to view the recordings you need to access the Play
function. The video list will be shown in sequence of date and
time of recording.Nota:
Each recording segment has a maximum duration
of 60 seconds.
Each file is approximately 4 megabits in size.

- 7 -
System settings
Image settings
Access the menu and select image using the cursor < / > and
confirm the selection using the SEL key.
Select the Brightness / Contrast / Color functions using the
cursor < / > and confirm your selection by pressing the SEL
key.
Modify the desired value of the selected function and press
menu to exit the configuration.
Image rotation
Enter the menu and select Mirrors using the cursor < / > and
confirm the selection using the SEL key.
Select the rotation of the desired image using the cursor < / >
and confirm the selection by pressing the SEL key.
Press menu to exit setup.
Split mode setting
Enter the menu and select Mode using the cursor < / > and
confirm the selection using the SEL key
Select the viewing mode of the screen with the images you wish
to view using the cursor < / > and confirm your selection by
pressing the SEL key.
Press menu to exit setup.
Camera setting
Enter the menu and select Camera using the cursor < / > and
confirm the selection using the SEL key.
Select the number of the connected camera using the cursor
< / > and confirm the On/Off selection by pressing the SEL key
Press menu to exit setup.
Note: it is possible to set the automatic rotation cycle of the
display (1-2-3-4) and the desired time.
System setup
Access the system settings and select image using the
cursor < / > and confirm the selection using the SEL key.
Select the functions: Date-Time / Language / Trigger /
Guidelines / System Reset using the cursor < / > and confirm
your selection by pressing the SEL key.
Modify the desired value of the function select and press menu
to exit the configuration.
Note: it is possible to set the automatic rotation cycle of the
display (1-2-3-4) and the desired time.

- 8 -
Specifications
Monitor
Screen .............................................................................................................................. 7’’ AHD IPS
Resolution ................................................................................................................ 1024xRGB*600P
Contrast ..................................................................................................................................... 500:1
Power Supply .................................................................................................................... DC12V-36V
Maximum current level ................................................................................................................ 10A
System....................................................................................................................PAL/NTSC (AUTO)
Connection ...................................................................................................................................WiFi
Registration
Way .........................................................................................................QUAD-Vision 4 rear camera
Video..............................................................................................................................................Mp4
Images........................................................................................................................................... JPG
Support
Typology ...................................................................................................................... Full SD HC/XC
Maximum capacity.................................................................................................................... 128Gb
Speed .............................................................................................................. Classe 10 (minimum)
Bus SD....................................................................................................................................... UHS-I
Categories ................................................................................................................ High Endurance
Note:
The Endurance category guarantees a greater amount of overwriting than traditional SD.
WiFi
Integrated Wi-Fi ............................................................................................................2.4G wireless
Network range............................................................................................................ 2403-2480MHz
Distance ............................................................................................................ ≤200m in open field
Camera
Sensor ................................................................................................................................. 1/3’’ AHD
Resolution .......................................................................................................................... 1280*720P
Viewing angle............................................................................................................. 110°[H] 140°[D]
Waterproof ................................................................................................................................... IP68
Night lighting ...................................................................................................................IR (infrared)
Night vision distance ............................................................................................................5 meters
www.macrom.it